Air Filters and Intake Manifolds

How do you fix intake gasket on 2000 lasabre?

012

Top Answer
User Avatar
Wiki User
Answered
2013-06-14 22:08:46
2013-06-14 22:08:46

The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


NO. You MUST replace the intake gasket.

you can go to any auto parts store and get a Hayes repair manual this will tell you how to fix your problems. Hope that will help with your intake gasket problems

You take off the carburater and the intake. Clean the old gasket off and install the new one.

no, You will have to replace the intake gasket, CAUTION DO NOT USE STOP LEAK.

It would be wise to replace the intake gasket with a new one than to try to fix the old one. How long it would take to replace the gasket would depend on the model, year and engine type you have.

$2200 is what I spent but it was head gasket and intake gaskets.

Had the same problem with my 2003 Axiom... It was my intake gasket. 50 dollar gasket.... easy fix

try checking the gasket around the intake that should fix it

How to fix this depends on where specifically it is leaking from.

blown head gasket is the usual reason for oil in coolant or radiator. sad part is if you have already replaced intake gasket, u wasted your money as you will have to replace again when you fix head gasket

Blown intake manifold gasket or blown head gasket, figure on $600 to $650 to get intake gasket fixed and if a head gasket your looking at least $1,000.

You will need to replace the intake gaskets to fix your problem. The HEAD GASKETS will not be your problem.

If you have a leaky intake manifold gasket, one or more cylinders may run extra lean. A lean burn condition can result in excess combustion heat and eventually burn valves or burn through a piston. Most mechanics will strongly recommend that you repair a leaking intake manifold gasket.

You drain coolant, mark and remove all hoses. Remove 8 bolts or so for intake. Pry intake back one inch or so, so just over studs. Scrape the old intake gasket off. Slip new intake gasket on. Tighten and torque the bolts. Add coolant, that was drained off. Verify the fix by checking engine vacuum at idle...15PSI, and steady.

no you need to replace the lower intake gaskets . P.S. should have the rear head checked for leaks also they are known to leak also

No it will not. The only thing that will fix a blown head gasket is to replace the gasket.

if water is in oil,could be a bad headgasket!have it checked out!or a bad intake gasket.

Take it to a mechenic asap....lady%preach

Replace the head gasket is the only fix.

With a new valve gasket

If you remove the head then of course you replace the head gasket.Where can you get sodium silicate to fix a blown head gasket?Know that adding sodium silicate to an engine is only a temporary fix for a blown head gasket and will not permantly fix the problem. The only permanent fix is to replace the head gasket. I would never add any head gasket fix material to any engine.

The only fix is to remove the head and replace the gasket.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.