0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What are the steps to getting rid of toxic mold?
The best effective cost-effective way to eliminate toxic mold on hard surfaces such as metal and hard plastic is through the use of a strong solution of chlorine bleach. On porous surfaces such as wood or fabric, removal and disposal is recommended rather than attempting to clean or eradicate the mold.
How is the silicon applied to the silicon bracelets?
Silica is placed into an electric furnace along with coal, wood, or charcoal. The reaction of the two creates silicon. The Silicon is then placed into a desired mold and cooled, creating the silicon bracelet.
How do you get rid of white mold on basement wall?
If its a wooden wall then the mold is (be the description) wet rot. To get rid of that you have to treat all the wood and replace any thats breaking up. Then you have to treat the source of the damp thats causing the wood to break down If its a rendered wall i.e. brick, block or stone that been cemented over then top coat plastered the its again damp forcing the salts out of the materials - You can brush it off and seal it with a stabliser or PVA but you really need to investigate the damps origin and deal with that first
How can you get rid of mold?
spray it with bleach let it sit and then spray with vinegar or water. repeat if needed ,leave bleach on for a night reapplying frequently.NOT true bleach and vinegar DO NOT kill mold go to EPA WEBSITE ..Kill mold with flo-X Mold and Mildew Cleaner for best results.Read more: How_do_you_get_rid_of_mold_on_flox_flowersThe biggest myth is Mold and Mildew Stain Removers, as a mold stain is the residue left over from dried out mold. THis means these products are only cleaning the stain left over after the mold is already dead, not actually killing the mold. Its a grey area where manufacturers of these cleaners are trying to get around EPA regulations. As for Mildew, mildew is a grime (dirt) not mold.
Does pine sol kill mold?
does pine-sol kill mold and mildue
Where does mold occur?
mold is found on foods, wood, plastic and building structures.
How long does it take wood to mold?
2 days
How do you fix water damages on wood?
Water on wood must be cleaned up immediately. Wood must be thoroughly dried out before mold sets in. If water has sat longer than 24-48 hours, mold has already began to grow. Wood must then be replaced and the area must be completely dried out and treated with a natural disinfectant to kill the mold.
Will wooden patio chairs mold in damp climates?
Wooden patio chairs will mold in damp climates. The best way to help prevent this is to have an exterior finish on the wood such as a mold inhibitor.
What type of wood should you put in a hermit crab tank that won't mold?
You should let it mold. It is part of life for a Hermit crab.
Can you use bleach on plywood?
yes but i would not do it if i was you but if takes mld of wood if it has mold
When is green wood safe to burn?
When the green can be felt such as mold although when it is imbedding in the wood that is arsenic and when you burn it the arsenic is transfered into the air.
Will a wood table get a lot of mold in a wet environment?
It all depends on if the wood was treated with a wood sealer and where the table is located. If the table is lcated in a primarily shady spot then without treatment it will mold in a few months, but if it's in a sunny spot then the moisture will evaporate. Also the general humidity also has an effect. If wood is treated with a sealer properly then the wood can withstand A LOT of moisture.
Would mold on wood be a chemica of physical property?
It is not a property at all! It is a status quo
Does wood fencing mold easily?
Wood fencing does in fact mold easier. Mostly due to the fact that it is constantly in contact with the outside world and things such as rain weaken it and make it susceptible to things such as mold over time. It may last longer if you paint and prime your fence in order to give it a seal and some protection.
How long would it take for mold to eat away a wood framed building?
research says that it would take about 5-10 years, it depends on the type of mold.
What is lots of tiny bright yellow spots on wood chips?
Lots of tiny, bright yellow spots on wood chips is likely mold. The area where the wood chips are is likely damp.
