Swimming Pools
Pool Care and Cleaning

How do you get rust stains out of a gunite pool?

001

Top Answer
User Avatar
Wiki User
Answered
2014-08-26 22:52:52
2014-08-26 22:52:52

Muriatic Acid will get rust stains out of a Gunite Pool. To prevent rust, it is recommended to keep pH level of the water slightly acidic.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Gunite, cement does not rust.

I seriously doubt that the pool sweep is the problem here with your stains. You will have to describe the stains in order to get to the root of the problem. Are the stains: Rust color or brown? Black or gray? Green? Blue? Are the stains consistent or uniform? Are they all over the pool? Do they cover the whole pool or are they in small patches? Answer these questions and I may be able to tell you the cause. k

How can I get rid of rust colored stains in my salt water pool. It is only in the shallow end?

Use a steal wire brush to brush off the yellow stains. Also, it might help to keep the chlorine level high.

How often should you resurface a gunite pool?

Pebble sheen is the finish on the surface of a pool gunite is the cement that a pool is constructed from in other words you can finish a gunite pool with pebble sheen.

See previous pool stain entries http://wiki.answers.com/Q/What_is_the_black_stuff_on_the_seams_of_your_pool

Put a chlorine tablet or shock in an old sock and weight it to the stain. It should be gone in a few hours.

Replace the tiles. Makes it easier to clean the water line. Stains and oils will be permanent if you don't. k

Have you tried muriatic acid? be careful with the stuff though.

The filter has nothing to do with the rust stains. You can remove small rust stains from a plaster surface with a small amount of diluted muratic acid. There is a tool specifically for this task which will make it easier to get the acid to the stain. The tool can be found in some pool supply stores. Ken

Either gunite or fiberglass will work well for an indoor pool.

how do i find and repair leak in gunite pool with water in it?

It can be used to remove rust stains caused by swarf or some metalic object lef laying in the pool. however if the rust is a result of reinforsement having come in cotact with the water No.

building pool myself just want to contract out the gunite job are you interested

Keep the acid content too high for a while and a lit of staining will tend to get bleached out.

The average cost of a gunite pool is $75,000. The price for the installation of this type of pool can range from $50,000 to $100,000.

Gunite is a trowled-on cement coating similar to stucco.

No Are you sure they are not tannin stains left there by leaves

You would go to a pool builder

You can use the same hole in the ground for both a vinyl liner pool and a gunite pool. You should not need a new hole dug.

The yellow stains are most likely algae. Superchlorinate and lots of brushing until it is gone. Then brush again. You may want to clean the filter too.

Ah, this pool is beyond saving with normal procedures of chemical treatments with the water in the pool. It must be drained and cleaned possibly using various or several methods.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.