The first step is removing the tires from the vehicle. Then the brake calipers will need to be removed. Once the calipers are off, take the cap off the area in the center of the rotor. This will give you access to the nut holding the rotor on. Removing the nut on the spindle gets the rotor off.
You don't need to take the rotors off to change the brake pads.
If you need to replace the rotors or get them turned, here's how to get them off:
1) Make sure you remove the 2 small Philips head screws.
2) give the rotor a hard whack with a hammer, if this fails you will need 2 bolts, (6mm I believe). The rotors have threaded holes to insert bolts to force the rotors off the wheel hub, (this is a poor man's gear puller). If this fails to break the corrosion weld, you have 1 last option - cut the rotors off. I had to go this route, but with an air cutoff wheel it was quick. All you need to do is cus a groove near the wheel hub and hit the rotor with a hammer. I was replacing my rotors, so thhis was no big deal.
Make sure you coat the hub surface with never seize and next time the rotors will easily come off.
You can tap the rotor off with a rubber mallet.
See: http://townhall-talk.edmunds.com/WebX?14@@.f0fe4be/4#4
No fasteners holding rotor on. But you must remove caliper and caliper mounting bracket first.
The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.
http://forums.genvibe.com/zerothread?id=26369
passenger side under glove box...you don't have to remove glove box to get to it...generation vibe forum has clear photos
where is the plug to drain the oil in a 2005 Pontiac vibe
City Vibe - 2005 was released on: USA: 3 October 2005 (Los Angeles, California)
The cast of City Vibe - 2005 includes: Branden Williams as Host
There is no aux in on the 2005 Pontiac Vibe. There is a button the says aux but the radio in fact has no aux it.
My 2003 Vibe has a split rear seat and each of these seats has 2 bolts at the front of the cushion. Simply unscrew these 4 bolts and lift up at the front of cushion. Needed this to clean out garbage which lodges under seat.
The 3rd Annual Vibe Awards - 2005 TV was released on: USA: 15 November 2005
The cast of Vibe - 2005 includes: Alejandra Barros as Host Gabriela Goldsmith as herself Alex Sirvent as Host
The frontdoes not havea "wheel hub assembly". It is an individual sealed roller bearing that has to be pressed on and off the front spindle. It is a Toyota thing!