answersLogoWhite

0


Best Answer

Go to Radio shack and ask. I'm not sure what it's called, but a little device that one end attaches to the two screws for the rabbit ears on the TV and the other end you plug a coaxial cable that will enable you to plug into a VCR or converter box

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you hook up an old Sony Trinitron to a converter box if the TV has only two screws for rabbit ears and no other inputs?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the o2 sensor located on a 94 dodge 318?

It screws into the catalytic converter.


Where are the oxygen sensors on a 2001 Dodge Ram?

The upstream sensor screws into the front of the catalytic converter. The downstream is screwed into the pipe after the catalytic converter.


Where is the O2 sensor on a 2000 jeep wrangler?

It's in the exhaust. It screws into the catalytic converter.


Where is the oxygen sensor on a 2001 dodge ram 1500 with a 5.9 motor?

There are two. The upstream screws into the catalytic converter. The downstream is in the pipe after the catalytic converter.


Where is the oxygen sensor on a 1995 Civic?

in the exhaust manifold (it screws in) or if not there it could possibly be screwed into the converter


What materials do you need to build a rabbit playpen?

Wood, screws or nails, and chicken wire.


Where is the 02 sensor on 1994 Chevrolet Suburban?

Probably either screws into the exhaust near the engine, or screws into the catalytic converter if it sits near the engine. HTH, Chuck


How hard is it to take a catalytic converter off a 99 kia sportage is it welded on or are there screws holding it in?

First off it is illegal to remove a converter without replacing it with a new one. This is a job best left to a muffler shop if you need a new converter.


How do you replace the catalytic converter on a 1991 Honda CRX?

Your catalytic converter is at the top of your motor at the exhaust manifold take out the 4 14mm screws that connect your converter to your manifold drop down out the bottom of engine and replace another really simple fix


Change air filter 2007 vw rabbit?

To replace the air filter on a 2007 VW Rabbit, you need to remove the screws holding the air duct, then gently push each end of the plastic engine cover and pull it off, rotating the unit to the side before removing several more screws to gain access to the filter. If you want to know where the filter is, there is a diagram in the engine compartment.


Is there a voltage regulator on a 1984 VW Rabbit convertible?

Yes. It's inside the alternator and is replaceable without alternator disassembly. Remove two screws and the voltage regulator will pull out.


Where is the oxygen sensor on a 2000 Buick regal ls located?

There are two sensors. One before the catalytic converter and one after. The first is at the back of the engine block on the manifold. It screws into the manifold and takes a special socket to remove (costs about $10). The second is between the converter and the muffler under the car. Its on top of the exhaust pipe and nearly impossible to change unless you take apart your exhaust system There are two sensors. One before the catalytic converter and one after. The first is at the back of the engine block on the manifold. It screws into the manifold and takes a special socket to remove (costs about $10). The second is between the converter and the muffler under the car. Its on top of the exhaust pipe and nearly impossible to change unless you take apart your exhaust system