That truck came equipped with a license plate light, so there should be a wire present for that function. Look for a disconnected wire behind the rear bumper. The wire would be live when the head lights are on. Connect a new light and make sure it is properly grounded.
Easiest way is to connect a single wire from one of your rear taillights "parking light" to the wire on license plate light. It gets its ground from the bumper once installed.
In 1952, the designation or code letter on a Georgia license plate for a pickup truck was A/p.
reach up behind the rear bumper, twist conter-clockwise and pull.
How do change a light on a steering column in a 2006 chevy truck?
How do you change a rear license plate bulb on a 2001 Buick Century?you have to remove the complete light panel from the truck lid and it's simple. there are about 8 wing nuts on the inside of the truck lid you unscrew, and then the panel just pullsout giving you access to the 2 sockets for the license plate bulbs. Just unscrew each socket counterclockwise, pull out the bulb and push in the new one. Then put the light panel back on the trunk and screw all the wing nuts back on.
The 1995 Chevy truck did not come equipped with an ashtray light. It may; however, be possible to purchase an after market light to install.
good luck
No. you have to have them both on the car or truck.
No, a license plate does not indicate how much a truck or trailer can carry. The carrying capacity is typically specified by the manufacturer and can be found on the vehicle's documentation, such as the owner's manual or a label on the vehicle itself. The license plate primarily serves as a means of vehicle identification and registration.
sgsdgsfgsg
the name plate
$293