Take and snip the following wires from the ignition wiring harness.
12 VOLT CONSTANT.
BLACK/BLUE (+) or BLACK (+)
STARTER
BLACK/YELLOW (+)
IGNITION
BLACK/PINK (+)
ACCESSORY/HEATER BLOWER
BLUE/YELLOW (+)
Strip the wires back on all of them and then connect all of them expect for the starter wires together. You're entire dash should light up once finished. After that just tap and hold the starter wire to the wires you connected until the car cranks. Last thing is to break the steering wheel lock with a flat head and or crow bar and Boom you're good to go.
Note if you have any security features installed you will need to find out how to disconnect them or else your car will not run.
yes....
Yessir, it will.
no, the 89-92 engine/transmissions are different from the 93-97 ford probe.
stock enginestock engine in 1994 ford probe GT is a Mazda 2.5L 24 valve V6.
YES it is
what is the spark plug gap for an 1989 ford probe lx? Thank you.
The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.
I want to know what is the proper spark plug gap for my car. It's a Ford Probe 1994, 4 cylinders and 2.0L
there is no such thing as a 1998 Ford Probe. If there was, it would probably still be located next to the stock airbox. follow the spark plug wires.
your firing order for your probe is 1-4-3-2
starting at the front of the car going from passengers side to drivers side wires should be 246 and in the back should be 135
Maybe this will help : http://mysree.wordpress.com/2007/12/11/fuse-diagrams-and-specs-for-1994-ford-probe-gt-v6/