1990 ford festiva dashboard light goes out when brake is applied and the instrutment guages some time don,t work what causes that
According to the Gates website ( they make timing belts etcetera ) Yes , the 1.3 liter four cylinder engine in a 1990 Ford Festiva has a timing BELT
Turn the Idle Adjusting screw.
My Chilton book shows ( .040 inch ) spark plug gap for a 1990 Ford Festiva 1.3 liter / 81 cubic inch 4 cylinder engine
The 1990 Ford Festiva 1.3 liter engine cylinder head bolt torque specification is 125 pounds. The cylinder head bolts should be torqued in 25 pound intervals.
Ford Festiva was created in 1986.
To install Ford Festiva front wheel bearing, the engine must be stopped and the car taken to a flat surface. The jack is usually used to lift the vehicle.
Installing wheel bearing in a Ford Festiva is simple but will take some time. All you have to do is take the hub off, take out the tie rod and then take out the wheel bearing from the hub.
Th easiest way to change the rotors on a 1990 Ford Festiva is to pay someone. However, remove the tire, remove caliper, remove the hub nut and washer. Remove the rotor from the CV axle. There four bolts on the back side of the rotor, but you may have to press out the rotor bearing. To re-install read backwards
Its under the right front fender, behind the bumper(passenger side)
1990 -1993 injected Festivas do not have a EGR valve
According to my Chilton's book : The spark plug firing order for the 1.3 liter / 81 cubic inch four cylinder engine in a 1990 Ford Festiva is : ( 1 - 3 - 4 - 2 ) The distributor rotor turns COUNTERCLOCKWISE