0
shove it threw the left valve cover and hope for the best
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What position do you install the cam bearings on a 307 small block Chevy engine?
Turn them so the hole lines up with the holes in the block.
How do you change a fuel pump on a ford galaxy?
Unbolt it and clean of any gasket that is left on the engine block. Install the new pump exactly like the old one cam off.Unbolt it and clean of any gasket that is left on the engine block. Install the new pump exactly like the old one cam off.
Will a after market cam affect the firing order on a 1970 302?
No, All Ford small blocks excluding the 351 winsor and Cleveland have the same firing order. Any cam that is specific to the small block ford should work fine, but not in a late model roller blocks made in the last years of the 5.0 mustang era.
How do you install cam bearings on a small block Chevy?
There is a special tool you can rent or purchase from most auto parts stores. Push out the old ones and press in the new ones, taking care to get the holes in the bearings aligned with the holes in the block.
Whats the largest cubic inch small block Chevy?
You can get a 454 c.i.d. small block Chevy with a 4.185 in. bore and 4.125 in. stroke on an aftermarket block with a raised cam
How do you adjust cam gears on 2001 ford focus se?
you have to buy and install adjustable cam gears. but if you adjust it improperly you will lose power/gas mileage.
Where is the cam position sensor on a 2000 ford ranger?
it is on the engine near the rear above the block and next to the firewall
How big of hydro cam can you put in a stock 350 small block Chevy?
Your best bet would be to contact a cam manufacturer for a recommendation. All the popular cam companies have websites.
Can you use big block cam in small block motor?
Nope. Too long, too big around, different spacing between lobes.
What is base timing for a small block Chevy with a performance cam?
4 degrees advanced initial, or about 30, total.
What is the biggest cam you can put in a small block Chevy?
I ground roller cams for Erson, that were up to .650 lift.
How do you make a 1969 ford 360 faster?
ford 390 heads, cam and 428 crankshaft. 360 and 390 shared the same block. you woul dthen have a 410 stroker
