0
What else can I help you with?
How do you remove a 2000 Mitsubishi eclipse door panel?
I just need to figure out how to take my door panels off my car, 2000 Mitsubishi Eclipse, so I can install some new speakers.
What models will a 2.4L out of a 2000 Mitsubishi Gallant fit?
2000 Mitsubishi eclipse 2000 Mitsubishi eclipse 2000 Mitsubishi eclipse
Oil pressure gauge on 2000 Ford Explorer only works after about 10-15 min of driving Why?
Test with a mechanical gauge to accurately detemine oil pressure Could just be a defective oil pressure sensor
What is the problem when the oil pressure light comes on when driving and blinks sometimes at idle on a 2000 Toyota Rav?
Check oil level Could be a bad sending unit Install a mechanical gauge to accurately check oil pressure Could be due to excessive engine wear (bearings)
How do you add freon for the ac on 2000 Xterra and how much should you add?
You'll need a pressure gauge and know how to use it. The gauge will tell you when you have the right amount in.
Will the motor from a 1996 eclipse rs fit in a 2000 eclipse rs-?
Yes. The motor from a 1996 eclipse rs can fit in a 2000 eclipse rs.
How to replace Fuel gauge sensor 2000 Chevy impala?
You will have to remove the gas tank and install a fuel control module. Before you do you need to have someone check for power and especially the ground for the fuel gauge.
Why Oil pressure gauge drops on 2000 ford truck?
Need oil change or oil pump weak or oil pressure sending unit not reading properly.
How many quarts of oil a Mitsubishi eclipse gt 2000 take?
4 quarts I had a 2000 eclipse GT
Will a 1999 Mitsubishi Eclipse manual transmission fit a 2000 Mitsubishi Eclipse?
Yes the transmission will fit in a 2000
How do you check the fuel pump of a 2000 Buick Le Sabre?
you will need a fuel pressure and flow gauge and then check actual meaured to specs.
How do you replace a transmission pressure solenoid in a 2000 Pontiac grand prix?
Begin by removing the wiring harness from your 2000 Pontiac Grand Prix transmission pressure solenoid. Remove the solenoid retaining screws. Reverse the process to install your new transmission pressure solenoid.
