it is at the engine end of the upper rad hose. REmove the housing and when you replace it make sure the spring goes toward the engine.
With A LOT OF PATIENCE!!!! it not an easy job and not for people with huge hands. If i remember right there are only two bolts holding on the housing, and i think the are 11mm. Once you get the two bolts off HANG ON TO THEM!! The housing is kind of difficult to pull out, take your time.
the bolts re 13 mm take loose water/heater small hose/es tie to tube side remove throttle body then take big pliers crush the shurerd cover over exhaust by housing you can see the bolts use a 13mm to loosening the bolt from under the housing than use a stubby 13mm wrencth got info from gm tech wasn't that tuff put bottom bolt in just start it
Chevrolet Monte Carlo was created in 1970.
The weight of a 1995 Chevrolet Monte Carlo is 1486(kg) or about 3276 pounds.
Follow the upper radiator hose bacx to where it goes into the top of the motor. The flange there houses the thermostat.
Drain the water from your 1997 Chevy Monte Carlo cooling system. Remove the water supply hose. Remove the thermostat housing retaining bolts. The thermostat will lift out. Reverse the process to install the new thermostat.
"The Chevrolet Monte Carlo, maufactured by General Motors, began production in 1970. The Monte Carlo was a two door coupe and production was stopped in 2007."
The Chevrolet Monte Carlo was last built in 2007 so that will be what this mileage is based on. The combined mileage of the Chevy Monte Carlo is 22 mpg. The Monte Carlo got 19 mpg in the city and 28 mpg on the highway.
Monte Carlo was produced from 1970-1988 and then again from 1995-2007
How do you install a new heater core on a 1979 chevy monte carlo?
The curb weight of a 1986 Chevrolet Monte Carlo SS is 3,295 pounds. Production of the Monte Carlo began in 1970, and ended in 2007.
The 1984 Chevrolet Monte Carlo starter can be found on the right hand side of the engine. The starter will be near the back of the engine.
The transmission modulator valve, On your 2006 Chevrolet Monte Carlo, is located on the top of the transmission. The valve should be labeled as such.
Remove the alternator belt from your 2000 Chevrolet Monte Carlo alternator. Remove the wiring harness from the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
V6 or V8?
yes next to tjhe oil filter on a 1997 monte carlo
Chevrolet produced approximately 1900 or so of the 1971 SS454 Monte Carlo
Chevrolet never made a Monte Carlo convertible of any kind
Remove the water supply hose from the top of your 2003 Chevy Monte Carlo thermostat housing. Remove the thermostat housing retaining bolts. Lift the old thermostat out. Drop the new thermostat in and reverse the process.
You don't. You replace a thermostat that has failed. They are meant to be replaced.
The fuel capacity of a 2000 Chevrolet Monte Carlo is 17 gallons.
Drain the radiator into a container. Follow the top radiator hose to the engine. Remove the clamp and the bolts holding the thermostat housing. Remove the thermostat and seal. Clean both surfaces and install the new thermostat and seal. Reinstall the housing and top radiator hose. Top off with antifreeze.jd
Joey AF R.
Under the thermostat
The thermostat on a 1999 Chevy Monte Carlo with a 3.1 is located just below the throttle body. It is covered by the top radiator hose attached at that location.