answersLogoWhite

0

Place the regulator in position and engage to the guide channel.Secure the regulator to the door (you may have to plug it in and lower the window the slightest bit to get it to line up)with rivets and a rivet tool.(you can use small screws but they can work their way loose so I don't recommend it) If the regulator won't line up, use the switch and let the window down slightly. Plug in electrical connector if you didn't already. Tighten all the channel nuts nd reinstall the door panel.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you change a window motor for a 1995 Chevy Camaro?

I need instructions on how to change the window motor in 1995 Chevy Camaro.


Where is a window regulator located on a 1995 camaro?

they are in the doors. the regulator is what makes it go up and down and is attached to the window motor.


What could cause the window in a 1995 camaro to not work?

check the following; fuses, relays, regulator, window motor, off track, window switch. did not specify if it was manual or electric.


Will a stock 305 motor from a 1986 iroc fit into a 1995 Camaro rs?

Will a stock 305 motor from a 1986 iroc fit into a 1995 camaro rs?


Troubleshoot window motor on Chevy Camaro rs 3.4l 1995 switch or motor when the window goes up and down in little bits over time if you fiddle with switch sooo new motor or new switch toggle?

9 outta 10 times it will be a bad power window motor. I rarely see the window switch go bad.


How do install a new passenger side power window motor in a 1995 Chevy G20 full size van?

not easy pass to a qualified window and door expert


How to install 1995 VW golf starter?

To install a 1995 VW golf starter, remove the motor mount. Disconnect the wiring on the motor step and install the starter.Ê


Can a 2003 Chevy Camaro motor fit in a 1995 Chevy Camaro?

no because the 2003 is bigger you wouuld have to cut it to get it to fit


Do you have to drop the motor on a 1995 camaro to change the head gasket?

you don't have to but it is tight in there.


How do you remove the driver's side door panel to replace the power window motor on a 1995 Cadillac eldorado?

The 1995 Cadillac Eldorado drivers side door panel is held in place by eight retaining clips. Pry outward on each retaining clip. The door panel will come off. Remove the linkage from the power window motor. Remove the wiring harness from the power window motor. Remove the retaining bolts. Reverse the process to install the new power window motor.


What years does a 3.8 litter Chevy camaro v6 motor fit?

1995-2002


How do you change the passenger power window motor for a 1995 Chevy Cavalier Z24?

Hi .. To change the power window motor .. Remove the door shell of course You will see the motor for the window .. Unplug the power of course . The motor is actually riveted in so you need to drill out the rivets. Remove the old unit . Then install the new motor with self tapping screws . Plug in the power . Be sure to secure the window when you remove the motor so it doesn't fall. I have not done this yet but am about to embark soon and have done some research . Good luck ..