0
You must put the car on jacks and get under it preferably when the engine is cool. Once under the car you will find the A/C compressor located under the brake fluid reservoir. Then locate the pulley which is just below the compressor if you are looking down into the engine bay then loosen this pulley by using a wrench or socket wrench with the nut that is directly in the middle of the pulley. Once complete the pulley should be loose enough to get the belt around it and the compressors pulley, if not you can use a belt stretcher found at any auto supply store. Once finished make sure to tighten the pulley back up but only enough so the belt is tight DO NOT OVER TIGHTEN. The belt well have longer life if tightened correctly. GOOD LUCK!
What else can I help you with?
How do you route the Alternator and AC belt on a 2001 Mitsubishi eclipse?
how do you route the alternator and ac belt on a 2001 Mitsubishi eclipse
Will a 2000 timing belt cover 4 Mitsubishi eclipse fit a 93 Mitsubishi eclipse?
No, it will not.
Does a 2000 Mitsubishi Eclipse GT have a timing belt or chain?
Timing Belt
How do you change the alternator in a 2003 Mitsubishi Eclipse?
Remove the wiring harness from the back of your 2003 Mitsubishi Eclipse alternator. Loosen the alternator tensioner bolt. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
How much does it cost to replace the timing belt on a 2003 Mitsubishi Eclipse?
The cost to replace the timing belt on a 2003 Mitsubishi Eclipse is about $700. This will depend on what else needs to be replaced and the dealer that you use.Ê
Replace timing belt on 2003 Mitsubishi eclipse?
99000 miles
How do you replace the cerpentine belt on a 2003 Mitsubishi eclipse?
Loosen the central nut of the belt tension pulley. Loosen the tightening bolt. Remove the belt, install a new one. Set proper tension. Tighten the central nut.
Where is the crankshaft position sensor located on a 1997 Mitsubishi eclipse gsx turbo?
In my '97 Eclipse GST (the convertible model of your car), the Crankshaft Position Sensor, or Crankshaft Angle Sensor, is located behind the crankshaft pulley. To get to it, the Mitsubishi shop manual lists the removal of the timing belt. Not a fun job. Since the timing belt will be removed anyways, this is a good time to install a new belt. The Mitsubishi dealership also suggested replacing the timing belt tensioner when re-installing the timing belt.
How do you change a fan belt in a 1998 Mitsubishi Eclipse Spyder?
there is no fan belt for that car. the fans are electric
When should 2005 Mitsubishi eclipse timing belt be changed?
Each 60K miles.
How do you change an alternator belt on a 1999 Mitsubishi eclipse gt?
To change the alternator belt on a 1999 Mitsubishi Eclipse GT, first, disconnect the negative battery terminal for safety. Loosen the alternator mounting bolts and the tensioner bolt to relieve tension on the old belt. Remove the old belt and install the new one, ensuring it follows the correct routing. Finally, adjust the tension on the alternator and tighten all bolts before reconnecting the battery.
How often should you change a timing belt on a Mitsubishi Eclipse Car?
Accoring to Mitsubishi every 5 years or 60,000 miles
