Remove the tire and wheel from your 1999 Chevy Cavalier. Remove the brake spring and the caliper. The brake pads will come off. Tap on the rotor with a hammer or mallet. The rotor will slide off. Reverse the process to install the new brakes and rotor.
Does Chevy cavalier have front shocks
Disconnect the positive cable from your 2003 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
The speed sensor(s) are located behind the brake discs on the front end
You rem ve caliper, remove old pads, fit new ones.
My 2003 Cavalier uses a 3/8 hex key. It probably should be the same.
Remove the tire and wheel from your 1998 Chevy Astro Van. Remove the brake spring and caliper. The brake pads will come off. Reverse the process to install the new front brakes.
blown brake hose, front passenger side in 1997 chevy malibu?
One tool, a telephone book. Call a mechanic and get the job done correctly.
You will need to remove the tire and wheel from your 1995 Chevy Cheyenne. Remove the brake assembly. Tap on the rotor with a hammer or mallet. The brake rotor will slide off. Reverse the process to install the new brake rotor.
All Cavaliers from '94 to '04 use a 3/8 Allen key on calipers.
The horn on a 2002 Chevy Cavalier is located in the front of the engine compartment. It is just behind the small air holes in the front fender on the passenger side of the vehicle.
It is on the front of the engine.
You probably have the brake pads reversed. There is one for the front side and another for the rear. The shorter one should be in the front.
The third generation of Chevy Cavaliers was from 1995-2005. So, you would think they would be compatible. However, Chevy gave the Cavalier a face lift in 2000. You can see more pictures and find more information here: http://en.wikipedia.org/wiki/Chevrolet_Cavalier
Replacing a front signal turn bulb on a 2000 Chevy cavalier takes all abut a few minutes to complete. First find the housing for the turn signal which is located in the engine compartment. Pull back the bulb from the light housing and remove it from the clip. Lastly install the new light.
I believe that needs a 3/8 Allen or some models, 7mm Allen.
How to Install Front Brake Pads Check Related links below.
One word for you...Brakes.....
botto right front under fender
its under the intake in the front of the engine
4x8 in the front and 6x9 in the rear