How do you install rear window on 1991 s10?

Answer 1

THE REAR WINDOW IS HELD IN BY THE RUBBER SEAL. REMOVE ANY TRIM NEEDED TO GET TO THE RUBBER SEAL. START TO WORK THE SEAL OUT BY PUSHING OUTWARD ON THE WINDOW AND LIFTING THE EDGE OF THE SEAL THE WINDOW WILL START TO COME OUT. ONCE OUT REMOVE THE SEAL FROM THE WINDOW IF YOU PLAN TO REUSE IT. IT JUST PULLS OFF THE EDGE AND INSTALLS THE ON THE NEW ONE WITH NO PROBLEM. INTALLATION CAN BE A LITTLE MORE TRICKY IF YOU ARE WORKING SOLO. SO IT WOULD BE BEST TO GET A BUDDY TO HELP YOU. IN THE RUBBER SEAL THERE IS A CHANNEL WHERE THE IT ACTUALLY OVERLAPS TO MAKE THE SEAL ONCE ON THE TRUCK. IN THIS CHANNEL YOU WILL NEED SOME CLOTHES LINE OR SMALL ROPE. PUT THE ROPE IN THE CHANNEL ALL THE WAY AROUND LEAVING ABOUT TWO FEET OF ROPE OUT ON EACH END OF THE ROPE SO YOU HAVE SOE THING TO GET AHOLD OF. SET THE WINDOW ON THE LIPSTARTING THE RUBBER. HAVE YOUR BUDDY PUSH IN SLIGHTLY AS YOU PULL THE END OF THE ROPE YOU CAN PULL EITHER ONE AS YOU PULL THE ROPE YOU WILL SEE IT PULLING THE RUBBER SEAL BACK OVER THE LIP OF THE TRUCK. WORK IT ALL THE WAY AROUND AND YOU ARE IN BUSINESS. SOMETIMES YOU CAN ALSO USE SOME DISH SOAP TO LUBE IT UP IF YOU HAVE TROUBLE BUT YOU SHOULDNT NEED ANY. HOPE THIS HELPS ANSWER YOUR QUESTION. I HAVE BEEN IN THE BODY BUSINESS FOR ABOUT 16 YEARS AND THIS IS A EASY FIX. ANYWAY GOD BLESS AND GOOD LUCK!