The complete headlight bucket assembly comes out so you can replace the bulbs easily. Open the hood, stand in front of said headlight, notice two locking tabs sticking up behind the headlight bucket, with a little effort pull up and wiggle each tab out, now wiggle the entire headlight assembly out in the open, twist and remove headlight socket in question, reverse proceedure to install.
Unscrew the trim piece around the headlights, be careful as to not lose this. Pull the light out, unplug, replace. Simple as that
You replace the truck ...it comes with new hinge pins :((
Remove the front grill to access the headlights.
No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.
The GMC S-15 became the GMC Sonoma in 1991.
Where is the timing connector on a 1995 gmc sonoma
will the 2.2 crossmember on a 1994 GMC sonoma fit on a 1994 GMC sonoma 3.4
To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.
The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.
were is csp on gmc sonoma 2.2
How do you flush the raditor on a 1992 GMC Sonoma Pickup.
where is the iat sensor located on a 2003 gmc sonoma truck