Just use any of the compter language, say C,C++ make a program or rather i should say a software and then connect the hardware to the printer port and then execute the program to operate the hardware.
For example make a simple program to glow an LED through the pc, you can even use a micro-processor for the same...
external serial ATA is six times faster
External serial ATA known as eSATA is up to six times faster than USB or Firewire.
In the past external modems connected to the COM (or serial) port. However, most modern external hardware is USB these days, modems are no exception.
External serial ATA (eSATA) hard drives is up to six times faster than USB or FireWire.
A universal asynchronous receiver/transmitter, abbreviated UART ( /ˈjuːɑrt/), is a type of "asynchronous receiver/transmitter", a piece of computer hardware that translates data between parallel and serial forms
the interface which is used to see the commands in serial communication with external devices in a windows operated PC.
A universal asynchronous receiver/transmitter, abbreviated UART ( /ˈjuːɑrt/), is a type of "asynchronous receiver/transmitter", a piece of computer hardware that translates data between parallel and serial forms
External SATA (eSATA) is up to six times faster than USB or Fire Wire
In the past external modems connected to the COM (or serial) port. However, most modern external hardware is USB these days, modems are no exception.
Its a 8051 based CPU with inbuilt flash memory(ISP - In-System Programming). It can be flashed through SPI(serial peripheral Interface). AT89C51RD2 has similar features but its flash memory can be programmed through serial interface (RS-232).
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
A COM port is the serial interface on an IBM PC-compatible computer. Through this interface, communication and information transfers in or out in an efficient manner.