Take it to a gunsmith. THIS IS A SERIOUS ANSWER!
This is notsomething you should do yourself. Removing 1/10th mm too metal from the sear assembly much can cause an accidental discharge.
It depends on which marker you have and which trigger is on it. Typically the manual will tell you how to adjust it
Rear trigger is "set" trigger, by pulling it 1st, it makes the main trigger a "hair" or lighter trigger
Yes, it lets you shoot faster, because of the lighter trigger pull, which only has to press a switch instead of tripping a sear.
5-7 lbs
Trigger, sights, MSH
No, it will work with the standard bolt.
Only some paintball markers require batteries. These use electricity to either trip the sear or fire the valve itself faster then a human can. It can be used simply to make a trigger pull lighter or to make a marker shoot multiple rounds per trigger pull.
Depending on what model, you may be able to find a replacement at a hardware store.
There are basically four things you can do. First is to replace the trigger spring with a lighter spring (like from a pen) to make the trigger pull easier. Second is to buy a double trigger, which may slightly increase your rate of fire, but not by much. Third is to purchase a response trigger, which uses excess Co2 from the Tippmann (which is automatically wasted after each shot) to reset the trigger faster than a spring. It will make the pull heavier, but allow you to shoot fully automatically if you place your finger where it sets, and resets. Last is the E-trigger, an electric solenoid and board that takes out the mechanical link from trigger to sear, and allows you to shoot semi, burst, and full auto. It runs on battery, makes the pull incredibly lighter, and must be turned off after every game, to preserve battery life, because without a battery, your gun will no longer function.
you cant make it lighter there is one way. buy one that's lighter.
How do make a wooden boat lighter
Mutt and Jeff Make a Hit - 1911 was released on: USA: 29 July 1911