Want this question answered?
1.4142 will give you the travel piece C-C then you deduct for the fitting
45˚
45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.
The 3 interior angles are 90 degrees, 45 degrees and 45 degrees
That is a icocsles triangle.
JIC and SAE flare are two common types of hydraulic fittings, but key differences set them apart. Here's a breakdown: Angle of Attack: The most significant distinction lies in the sealing surface angle. JIC fittings utilize a 37-degree flare, while SAE flare fittings typically have a 45-degree angle. This seemingly small difference translates to significant variations in sealing pressure and interchangeability. Pressure Rating: JIC fittings generally boast higher pressure ratings compared to their SAE counterparts. The 37-degree angle creates a tighter seal, allowing JIC fittings to handle higher fluid pressures within a hydraulic system. Material and Application: JIC fittings are primarily made from robust materials like steel for their high-pressure capabilities. They're commonly found in industrial and construction applications where high pressures are a norm. SAE flare fittings, often made from brass, can handle moderate pressures and are frequently used in refrigeration and air conditioning systems. Interchangeability: Due to the different flare angles, JIC and SAE fittings are not directly interchangeable. Mixing them can lead to leaks and potential system failure. However, there's a caveat. SAE J514, a specific type of SAE flare fitting, also utilizes a 37-degree angle and might be interchangeable with JIC fittings in certain situations. It's crucial to consult the manufacturer's specifications for confirmation. In conclusion, JIC and SAE flare fittings serve different purposes. JIC excels in high-pressure applications, while SAE caters to moderate pressure needs. Understanding the angle, pressure rating, and material differences is key to selecting the right hydraulic fitting for your specific needs.
1.4142 will give you the travel piece C-C then you deduct for the fitting
Some fitting may be required
A draper's measure of 45 inches is called an eil.
11 1/4"
45
45 apex(:
45 degrees
45˚
46 grams for a female.45 grams for a male.
45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.45 inches = 114.3 cm.There was an old measure, the ell, which was 6 hand breadths. This was "standardised" to 45 inches.
90 degree angle rolled on a 45