In researching what to paint the polyethylene gas tank in my boat with, it seems that exterior acrylic latex paint should work.
Polyethylene Which is stronger Polyethylene or dyneema?
Chemical structure of polyethylene?
Periodic table lists elements, and not compounds like polyethylene
CH3(CH2O)n is the formula for polyethylene oxide.
Try Tetralin (1,2,3,4-tetrahydronaphthalene) as a solvent for polyethylene.
Polyethylene can be painted with a moderate amount of success if properly prepared. You should only use acrylic paint on polyethylene. The surface needs to be cleaned and scuffed up with a fine grit sandpaper to hold the paint.
Some red buoys are known as "nun" buoys.(Ref: SB-4)some red buoys are known as nun buoys
Mooring buoys
Some red buoys are known as "nun" buoys.(Ref: SB-4)some red buoys are known as nun buoys
Mid channel buoys
Polyethylene Which is stronger Polyethylene or dyneema?
Regulatory Buoys.
Yellow buoys are weather stations.
Yellow buoys are weather stations.
Anchor or mooring buoys do not have lights
Not really, paint does not stick to polyethylene very well and would make the slide rough rather then 'slippery'.Alternative:Actually, some forms of epoxy paints will adhere to polyethylene. The issue is roughness again. If you prepare the surface by sanding it smooth, and spray the paint in layers, sanding each layer with progressively finer grit sandpaper, you should be able to produce a smooth enough finish to make sliding feasible. You might also need to wax or polish the slide's surface after the last coat of paint has set completely.If however there is any portion of the surface of the slide that is dirty, or has any sort of oil on it, the paint will not adhere there, and will create a peeling point that could spread over the entire surface of the slide.
Some red buoys are known as "nun" buoys.