bring it to a mechanic...lol . that's what i had to do.
1994 toyoa supra n/a
No. It is rear wheel drive
Sorry buddy but there's no such thing as a 2004 Supra. Toyota ceased production on the Supras in 2002.
The lug/wheel bolt pattern for the 1986.5-1992 Toyota Supra (Mk III) is 5 x 4.5"
the wheel bearings are press fit bearings you need to pull out the drums and take them and the new bearings to a machine shop they can press them in a few minutes and fairly cheep to do
Changing wheel bearings on a Toyota RAV4 is similar to other vehicles. After properly and safely removing the tire, the cowling should be removed giving access to the bearings. Be sure to clean the housing area and properly pack the bearings.
yes
To change the front wheel bearings on a 1999 Toyota Avalon, start by lifting the vehicle and removing the front wheel. Next, disconnect the brake caliper and rotor, then remove the hub assembly by unbolting it from the steering knuckle. After removing the old bearing from the hub, press in the new bearing using a bearing press, reassemble the hub, and reattach the brake components and wheel. Finally, lower the vehicle and ensure everything is tightened properly.
To replace the front wheel bearings on a 1994 Toyota Tercel, first, lift the vehicle and remove the front wheel. Next, disconnect the brake caliper and rotor, then remove the hub assembly by taking out the hub nut and any retaining bolts. Carefully press out the old wheel bearings from the hub and replace them with new ones, ensuring proper alignment and lubrication. Reassemble the hub, rotor, and caliper, and then reinstall the wheel before lowering the vehicle back to the ground.
A wrench
How do I put a wheel bearing on with out a wheel bearing press
no Camry motors are for front wheel drive vehicles and supra motors are rear wheel motors which means the way the motors are turned are different.
The bearings are pressed into the knuckle so you have to remove the knuckle and then press out the hub (wheel studs) and then remove the clip and press out the bearing cant do it unless you have a 10 tonne press