Power Steering
Chevy Silverado
Chevy Monte Carlo
Pulleys

How do you pull the power steering pulley on 98 Monte Carlo?

181920

Top Answer
User Avatar
Wiki User
2005-11-26 11:03:01
2005-11-26 11:03:01

A special tool is needed to pull the pully that you described. If you have a DIY auto parts store anywhere near, such as Checker, Schuks, Kragen, Auto Zone or Pep Boys, they should have the tool that you can rent or borrow, or they should be able to remove it for you in just a few minutes.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

It is serviced in the power steering reservior.jd

User Avatar

Start by removing the lines, drain the fluids, then remove the pump pulley. After that, remove the mounting bolts.

User Avatar

in the top of the power steering reservoir on the passenger side of the engine.

User Avatar

where do i put the fluid Its under alternator.

User Avatar

Remove cap to power steering reservoir, add fluid, place cap on reservoir when done.

User Avatar

on the front of the engine and it is run by the serpentine belt.

User Avatar

right behind and below the power steering pump on the block.

User Avatar

its located behind the power steering pump...you would have to remove the power steering pump to access it

User Avatar

water pump is located right front corner just across from coolant tank.fwd of power steering pump next pulley over.

User Avatar

on the passenger side of the car and it's driven by the serpentine belt.

User Avatar

On the 2004 Monte Carlo you may want to check with the dealer but I believe that this car was equipped with electronic steering assist and does not have a belt driven pump

User Avatar

Power steering pulley puller Snapon?

User Avatar

Power steering usually powered by that pulley.

User Avatar

My brothers 2003 Monte Carlo had this problem, was a plugged catalytic converter.

User Avatar

That requires the use of a power steering pulley PULLER. ( A special tool ) The pulley is pressed on.

User Avatar

it controls all lights, guages, fuel pump, power breakes, anything power,............... power steering ect

User Avatar

how to remove a power steering pulley on a 1997 Nissan altima

User Avatar

This requires a power steering pulley puller. This puller is designed to remove and install a power steering pulley without damage to the pulley and or pump. Attempting to do this without the puller will result in damaging the pulley or the pump or both.

User Avatar

Check your hoses from the power steering reservoir for cracks in them and also check the power steering rack on the firewall to see if the rubber seals on the ends of the rack are leaking, maybe the reservoir itself is leaking, have it checked out.

User Avatar

Begin by removing the power steering pump belt from your 1991 Cadillac power steering pump pulley. Remove the power steering pump pulley retaining bolt. The retaining bolt will be in the center of the pulley.

User Avatar

It requires a power steering pulley PULLER. You can rent them at some parts stores.

User Avatar

The Power Steering unit is located under the alt. Make sure the engine is cold. Very tight area. I connected a rubber hose to the bottom of my funnel.

User Avatar

Replace o ring between tank and pump clips slide off tank

User Avatar

It is not possible to remove the power steering pulley on a 1997 Buick Le Sabre without removing the power steering pump.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.