Why would you want to empty air out of your car - if it were possible to actually do this and create a vacuum inside the car, the atmospheric pressure would crush it.
The computer on the car purges the evap canister automatically by activating the purge solenoid.The computer on the car purges the evap canister automatically by activating the purge solenoid.
Bleed it /Purge
The purge solenoid that vents the air from the gas tank as it fills is immediately behind the rear wheel well on the left (drivers) side. Be sure to check if you have no voltage on the solenoid when the car is shut off.
park your car on a steep hill and let run until you see or hear all the air bubbles come out
It's possible you'd need to purge the air in the system. Easiest way is to start the car and turn the heater to the hottest setting. Let the car run until fully warm with the radiator cap off. Let the car cool completely off and top off the coolant. Depending on how low the system is you may need to do this a couple of times.
In the movie "The Purge Anarchy" a mother and daughter's car breaks down. They are then rescued by a vindictive man who is out on the night of the Purge so that he can kill murderers, after his son was killed on the Purge Night. To answer your question, the purpose of the car was to transport the mother and daughter from a location to another. For example, from school to home. Another example, from the shopping mall to a restaurant. I hope this was helpful.
The canister purge valve on a 98 Eclipse is located on the front of the car. It is on the right corner of the bumper.
no, you are trying to get the air out of the system, not fill it full.
fill radiator up the start car after the thermostate opens it will do the trick after running awhile let car cool off then check water in radiator if needed add water if not close it up.
With a freon recovery/recycling machine.
No.
Canister purge valve is located under the air cleaner assembly, remove the aircleaner and the airintake hose, remove air filter, underneath in air cleaner housing are 2 7/16 nuts,remove and take housing out. canister is underneath. valve closes to canister is the purge solenoid.