you open the cap that says brake fluid, and then you pour it in
Not a problem at all.Not a problem at all.
You have your car towed to a repair station where they will bleed the brake fluid and grease out of the brake system, and replace them with good, clean brake fluid.
Oil, Antifreeze, Power steering fluid, brake fluid, transmission fluid, coolant...
Do not drive the car. Have it towed to a repair shop and have the brake fluid changed.
No. Get it fixed as soon as possible. When you have brake fluid leaking out of your rear cylinder, you are putting lubricant on your rear brake. That is keeping that brake from working. It is also letting brake fluid drain out of the car. Your car needs brake fluid to stop the car. If you lose a lot of brake fluid, you will put your foot on the brake pedal and it will go all the way to the floor and nothing will happen. It can be dangerous when you drive down the highway at a high rate of speed and put your foot on the brake pedal and nothing happens. When you crash your car and turn it into a piece of scrap metal, you could get hurt.
You put brake fluid in a 1990 BMD 525i in the brake fluid reservoir. This is more than likely located on the master cylinder of your braking system, under the hood of the car.
It is important to use the right type of fluid in a car. The Brake fluid for this car is DOT 3 brake fluid.
You put the brake fluid inside the brake master cylinder
in the master cylander fluid resevoir,which is located under the hood on the front of the brake booster, generally on the drivers side
you put the brake fluid inside the master cylinder
To put brake fluid in a 1997 Ford Explorer, you must locate the brake fluid reservoir. Once you locate it, unscrew the cap, and replenish the brake fluid.
in the brake fluid bottle. >:D