0
You need the services of a gunsmith.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Can you buy a bipod for a Spring M57A Bolt Action Sniper Rifle?
Yes you can put a bipod on any rifle.
For call of duty world at war can you put a aperture scope on a bolt action rifle?
No, however you are able to get a sniper scope for all of the bolt action rifles.
How do you load a Marlin bolt action?
you pull bolt out put bullet in and push bolt back in
What is age of Marlin bolt action 22 rifle?
No way of knowing without a serial number and model number to put to your .22cal rifle.
Can you put a scope on a 270 bolt action rifle?
if it did not come with the provision to mount a scope on it you can take it to a gunsmith and have it drilled and tapped for one.
How do you disassemble a R-E Terni rifle 6.5 Cal pics please?
open the bolt all the way back and pull trigger and bolt will pull out do the same to put it back in
How do you load a tube fed bolt action shotgun?
put the bulit in than pull the tricker back
Remove bolt from Marlin 81-dl-22 cal rifle?
Put the safety on.....and while pulling back on the trigger (make sure gun is unloaded first) the pull the bolt rearward and remove the bolt. Putting the bolt back in is just the reverse...slide the bolt back in while pulling the trigger back first...the bolt will slide right in. JR
How do you remove the bolt on a Winchester Model 310 22 cal single shot bar?
Make sure the rifle is unloaded. Then close the bolt. Then open the bolt, but do not pull it back. Now, pull and "hold" the trigger pulled back, and then slide the bolt back and it should slide right out of the receiver. To put the bolt back in, do the reverse (hold the trigger back and slide the bolt back into the receiver, then release the trigger).
How do you assemble a Winchester 243 lever action rifle?
The only Winchester made lever action rifle was the model 88.I would refer you to a good gunsmith to put your model 88 lever action rifle back together again,as these rifles are complex and should not be attempted by a novice.
How do you put the bolt back together on a J C Higgins Model 21 rifle?
The JC Higgins Model 21 is a pump shotgun, not a rifle. Reassembly should be done by a competent gunsmith.
How do you get the bolt out of the model 41?
I have a Model 41 J.C.Higgins single shot S, L,LR 22 cal. rifle. The question was how do you pull the bolt out of it. If that's all you want to do , then make sure it is unloaded by pulling the bolt up and back, then just hold back on the trigger and continue holding the trigger back . The bolt will slide right out of the receiver. To put it back , make sure the firing pin is lined up with the slot inside . But they are right about one thing , The model 41 is one of the best shooting little rifles I have ever had. My mother bought mine when I was 10. I still have it. AnswerMake sure the rifle is empty . Remove action and barrel from stock. Remove large screw on bottom of stock and lift barrel and action out of stock. On the bottom of action about an inch ahead of the trigger is a screw, remove this screw. With one hand hold trigger back all the way. With other open bolt and pull it back until the bolt is clear of receiver and out of the rifles action. . The bolt assembly on these rifles is two piece witch consists of the actual bolt and a cylinderical crome plated part called the Feed throat. It is important when reassebling the gun to put tht feed throat back on the bolt as you found it before putting it back in the rifle.as you can damage the bolts extractor be carefull.These are one of the best single shot 22 rifles ever made they are of a very unique design very fuctional and one of the most accurate 22s of their class. it was made around 1961.
