0
How do you relight hot water heater which has been under water?
Wiki User
∙ 14y ago
If the control got under water, you probably will have to replace it. If it was just the burner, you can take the tube loose where it connects to the control and blow out the water in it. You should be able to relight it after that.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why are we running out of hot water so soon?
Either the thermostat has been set too low, your hot water heater is not big enough, or your hot water heater has not been installed properly.
Is it called a hot water heater or water heater?
It's because "hot-water" is a compound adjective, modifying "heater". It's not for heating water, it's for heating a house with hot water. There are many types of heaters that heat water, but only a hot-water heater is used for providing heated water for domestic use. A hydronic boiler also heats water, but it's only for use in radiators.The name "Hot Water Heater" is completely wrong for any use. There is no need to heat hot water. IT has always been "water heater". The term hot water heater has just been used for years because people don't realize the difference. It has always been WATER HEATER.The first answer is jibberish and makes no practical sense at all.
Why does the water heater moan after use?
This could either be due to the age or the materials used to make the water heater or the fact that the water heater has not been installed with vacuum breakers causing the geyser to collapse from the inside-out due to incorrect atmospheric pressure within the water heater
Why would a hot water heater only running for about 30 seconds Anyone have any thoughts as to why?
either your hot water heater has been installed incorrectly or the thermostat has been set too low Sorry to butt in BUT there is NO THERMOSTAT on a hot water heater there is a AQUASTAT and sometimes the heater short cycles just to maintain the SET temperature
Was there been a pyramid found under water?
no there has not been a pyramid found under water
What would be the cause of a 94 Dodge 15-passenger van to not blow hot air the thermostat has already been replaced and it has a new ac compressor and condensor?
The heater core may be stopped up. This can be cleaned by removing the heater hoses under the hood of the van and running water through the heater from a water hose. Disconnect the hoses from the front of the engine.
How Does water get in the ECMcomputer?
AnswerLeak or the car has been under water. I would suspect the latter.Your heater core could be in that area. Or there could be a hole in your car frame and water may be following your computer wires. What year, make, model, and engine size is it.
94 Ford Aerostar V6 the heater hoses that come off the water pump and go to the heater core how can you tell if they have been reversed?
Doesn't matter which way the water flows. The heater core is just a tube with fins and water can flow either direction.
Electric Water Heater?
form_title= Electric Water Heater form_header= Save with an electric water heater. Do you currently use an electric water heater?*= () Yes () No () Not Sure Do you have any problems with your current heater?*= () Yes () No () Not Sure How old is your home?*= _ [50]
Why is your disconnected heater core still leaking?
There may have been some water left in the heater core when you disconnected both hoses at the firewall. I can't think of any other explanation since there is no water circulating through the heater core.
When the thermostat in the car has been replaced and the car runs right what is wrong with the heater?
usually it is a vacuumn problem right at the heater control switch or sometime under the hood
How long does it take water to get hot in a gas hot water heater that has been shutoff for several months?
15 minutes to half an hour.
