You have to remove the center of the axle plate and the axle to remove the brake hub.
Loosen and remove center hub bolts Slide axle out Remove spanner nut Remove drum
You can take the hub and shaft out at the same time with out removing the nut. just remove the wheel bearing hub assembly bolts (should be three) and then pull the hub assembly out, they will stay together.
Yes you can, The axle will stay attached to the hub in that situation though. After the brakes are off you will see bolts on the rear of the knuckle holding hub on. Lossen bolts about 1/4 in. Using an old socket start to hammer on the bolts until the hub comes loose. This can be a challenge.
Remove the tire and wheel. Remove the brake assembly and rotor. Remove the axle end cap. The rear hub assembly will come off.
Just pull it out. There should be nothing holding it in the differentail after you remove the locking hub and the hub.
That might be the rear axle, it that is what you want to remove then you will need to remove the rear axle cover drain the fluid and the locate the center pin bolt and remove that in order to remove the center pin to get at axle c-clips then remove the c-clip for the axle you want to remove then slipe the axle out being careful not to distrub the axle bearing
remove wheel, disconnect tie rod end, separate lower ball joint from control arm, remove axle nut, slide hub off axle, pull axle from transaxle housing
Did you remove the big snap ring that's inside of the hub. It's hard to see.
remove the axle nut on the side with the brake hub...and pull threw the other side....very simple
you have to remove the axles by unscrewing all of the small bolts in the center hub after removing all the lug nuts. pull the axles out and then you will need to rent a axle nut socket to remove the axle nuts. then remove the entire hub with the rotors attached then flip the hub over and remove all of the torx bolts holding the rotor to the hub
remove the wheel remove the brake caliper braket assembly remove rotor.remove the axle shaft to hub nut remove hub retaining bolts.remove hub probably with hammer.big hammer.install new hub reverse proceedure