All you hace to do is un screw the faucet take the sink part off, If that dosent work then call a plumber. Or your dad to come fix it
The break and repair events probably released debris into the pipe. These eventually get caught in the faucet valve and it may have to be disassembled to remove them. check the areator
There should be a nut around the chrome pipe holding it to the brass. Loosen the nut and pull the chrome pipe out.
Call a pumer
An inside pipe wrench also called a pipe extractor. It drives into the broken off pipe and is then turned with a crescent wrench.Normally a extractor or inside pipe wrench does not work removing a pipe . What works best is the use of a hack saw blade and a chisel to cave in the threads after the threads are cut.. BECAREFUL not to cut into the fitting threads
Nozzle is a noun which is defined as meaning a faucet or spout of a pipe or hose. Some synonyms for this word are tap and faucet. Other synonyms include spigot.
It may be easier and cheaper to buy a whole new faucet.
Someone may have shut off the water to that faucet, or a pipe may have froze, or there may be air in the pipe.
It may be easier and cheaper to buy a whole new faucet.
Extractor.
To raise the height of an outdoor water faucet, the best thing to do would be to get an extension for the existing pipe that will bring the faucet to the height desired. Remember to turn off the source of the outdoor faucet before starting this project. Remove the faucet valve, screw in the new pipe, replace the faucet valve. Sealing the ends of the new pipe with plumber's tape is also a good idea.
threaded pipe use an extractor
You can extend the faucet pipe by, getting an extra metal pipe and welding it with the faucet pipe and it shall be extended.
If it's the drain pipe, tilt your machine over and remove it from the pump, clean it out by holding it tight to an outside faucet. -You now need to check the strainer/filter in the floor of the machine, it may be broken.
A clogged pipe can cause the water to flutter out of one faucet in the house only on the hot side. A broken valve can also cause this.
Shut of the water to the faucet. If a local shut off is not present then the main house shut off will have to be used, or the cutoff at the meter. unless plastic pipe is used then the faucet screws onto the water pipe. It will probably take a pipe wrench on the pipe and the faucet to break it free. use Teflon tape to cover the pipe threads before screwing on the new faucet. Turn the water back on and check for leaks.
Rust popped off inside the pipe and plugged the faucet.
The break and repair events probably released debris into the pipe. These eventually get caught in the faucet valve and it may have to be disassembled to remove them. check the areator