there is no drive shaft it's front wheel drive
Chock the wheels to be sure vehicle will not roll. Mark the differential and drive shaft before removing drive shaft. Remove 4 bolts from differential-end of drive shaft. Place a pan under the transmission-end of drive shaft and have clean rags handy. Push the drive shaft slightly toward the front of the vehicle while pulling downward on the drive shaft and lower it to the ground. Pull the drive shaft toward the rear of the vehicle until the front of the drive shaft pulls out of the transmission. Place the drive shaft on the ground and put rags in the transmission to prevent oil leakage and keep dust/dirt out. Assemply is reverse of removal with special attention to aligning marks on the drive shaft to the mark on the differential.
how to remove a fender on 99 taurus
you can remove the engine from the top by leaving transmission still in car
Remove rear bumper on 99 ford tarrus
To replace the slave cylinder on this vehicle you will have to remove the drive shaft and then the transmission. The slave cylinder will be bolted to the inside of the bellhousing. The transmission is very heavy so be very careful.
Sounds like you have a bad drive shaft.
is it safe to drive from new orleans to fort lauderdale in a 1999 ford taurus with 155k miles <><><><> Impossible to answer without knowing the condition of the car, and how well it has been maintained.
Remove the old follow same routing to replace with new
Yes, a 1999 Ford Taurus Sho Engine will fit in a 2007 Ford Taurus.
No, the rear axle shaft does not have an internal retainer clip. You remove the four nuts on the inside of the brake backing plate and remove the axle shaft with a slide hammer and hub adapter.
The fuel pump on a 1999 Ford Taurus is inside the fuel tank.
is there a fuse box under the dash on a 1999 ford taurus