Pontiac Vibe
Door Panels and Handles
Ford Expedition XLT
DIY Projects

How do you remove a driver door panel on a 2003 Pontiac Vibe?

575859

Top Answer
User Avatar
Wiki User
2006-06-22 18:21:37
2006-06-22 18:21:37

The Generation Vibe Forum has the answer you are looking for (The same question I was looking for too). Here is the website that I found your answer http://forums.genvibe.com/zerothread?id=785. The discussion talks about removing the panels to replace the speakers. Hope this helps.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Using a screwdriver remove all the screws in the door panel, remove all of the clips, and pull the panel away gently. Remove any wiring connectors, and pull the panel off the door frame.

User Avatar

how do you remove the door panel for a 2003 mitisbushi montero

User Avatar

there is screws around the door panel and the right under the handle there is 2 of them then your door is off hope this helps you :)

User Avatar

Remove the front driver side tire. There is a panel that comes off to expose the battery.

User Avatar

how do you remove the back seat in the 2003 poniac grand am

User Avatar

To remove the door panel on a 2003 Toyota 4 Runner, locate the screws holding the panel to the door. Unscrew these and lift the panel up and away from the door.

User Avatar

Use a screwdriver to remove all the screws and clips in the doors panel. Pull the panel away slowly, remove the wiring connections and the panel will come off easily.

User Avatar

The 2003 Kia drivers side door panel is held in place with two retaining clips and 10 retaining clips. Pry outward on each retaining clip and remove the retaining bolts.

User Avatar

Remove the switch panel by prying upwards with a flat screw driver once the panel pops out the group of switches will have some screws usually 4 or 5 then pry around the locking tabs it should pop out allowing you to remove each individual switch.

User Avatar

driver side. Under steering wheel. Remove knee panel. The BCM will be in center with 3 plugs connected

User Avatar

To replace the driver side mirror on a 2003 Ford Focus you will need a socket and a Philips head screwdriver. Loosen the driver side door panel so that you can reach inside to unplug the wiring harness, and then remove the bolt and screw to remove the mirror. Put the new mirror in place and reattach everything you just removed.

User Avatar

The one location to where the fuses for the air conditioner can be on a 2003 Pontiac Vibe. The fuses for the air conditioner will be in the fuse panel located in the engine compartment.

User Avatar

what you need to do is remove the panel which you will just have to pull its on by clips.The radio is screwed on so youll need a phillp to remove it.

User Avatar

To remove the door panel from a 2003 Honda Pilot all the mounting screws must be found and removed. There will be 2 screws and 8 clips holding the panel to the door. After removing the screws the door panel will be able to be pulled off.

User Avatar

On the left side kick panel ( drivers footwell ) remove the panel cover to access the fuses

User Avatar

The 2003 Pontiac Montana EGR valve is located on the firewall. The valve will be on the driver side of the firewall.

User Avatar

The cabin air filter is located just below the wipers. Raise the hood and look on the black panel. It is directly in the middle. Use a flat head screw driver to remove the panel from the rubber gasket.

User Avatar

Near the Driver Side Kick Panel

User Avatar

The 2003 Mercedes-Benz C2 40 front interior door panel is held in place by eight retaining clips. Pry outward on each retaining clip to remove the door panel.

User Avatar

Remove the fuel cap on the 2003 Pontiac. Remove the plastic cover around the filler pipe by taking the two screws out. Under the plastic there are two nuts that hold the door and hinge assembly on. Remove them and the door will come off.

User Avatar

The tire locking nut on a 2003 Pontiac Montana is removed by using a special tool located in the truck of the vehicle. It meshes with the locking nut which allows it to be easily removed.

User Avatar

The door panel on a 2003 Nissan Frontier is removed by removing the trim and retaining screws. A screwdriver can then be used to pry along the edges and pull the panel off.

User Avatar

Begin by removing the radio cover in your 2003 Pontiac. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.

User Avatar

Remove the black plastic covering from the top corner of the door panel (the piece that covers the bolts that hold the mirror in place) by pulling it straight out. It is held in place by single clip that will give if you apply enough force. Remove the screw that is underneath that attaches the top of the door panel. Remove the screw at the bottom left corner of the door panel. Using a flat head screw driver, pry the plastic piece behind the door handle out. There is a small tab in this to insert the tip of the screw driver. Behind this piece are two screws. One holds the door handle in place, and the other attaches to the door panel. Remove the one holding the door panel. Remove the controls for the windows and door locks by inserting the screw driver in the slot on the unit (similar slot to the one by the door handle). Remove the screw underneath that attaches to the door panel. Working your way around the door panel, loosen all of the edges from the door frame. Lift the door panel straight up and out.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.