behind the glovebox, remove it and the filter should be in the left, you have to removed a butterfly shaped holder and then pull out the old filter
Remove the fuel tank. Disconnect the fuel hose from the fuel pump to the junction of the carbs. Disconnect the fuel hose from the fuel filter to the fuel tank. Remove the fuel filter bracket. Keep track of the position of the fuel filter. Remove the fuel filter from the rubber holder. Disconnect the fuel pump electrical connector. Remove the fuel pump from its holder bracket A large screwdriver may be necessary to pry pump away from the holder bracket. . Remove fuel pump assembly. Remove remaining hoses from fuel pump. Installation is reverse of removal.
The fuel filter is on the passenger side of the engine compartment, near the rear. Remove the filter from the holder, and pull it up high enough to remove the fuel lines. Reconnect the fuel lines to the new filter.
Remove the glove box door. The cabin filter is in a holder on the left side of the heater core.
It can be found by removing the glove compartment door. There will be a thin rectangular holder, pinch the sides and remove to reveal the air filter.
Open the glove box, remove the 2 sides screws and let the box hang down. You are now looking at the filter holder. Pull out and replace the filter.
If its a cartridge style replacement filter(as opposed to a spin on), then simply unscrew the hex-head shaped holder with a crescent wrench...:)
I have a 1994. I think it is in the same place. It is under the hood below the air filter. Remove the air filter holder (cleaner). Remove the Windshield washer bottle. It is under the panel in a 'well' below that.
1. Open the glove box and squeeze the sides together to open it further. There may be a motion damper on the right side of the glove box that makes it open slowly. This is difficult to remove and replace. When you open the glove box beyond it's normal operating range of motion. You will be able to see the white plastic filter holder behind. 2. Remove screw around the opening of the glove box. I believe there are 2 at the top and 2 on the bottom. 3. You can pry the plastic cover down slightly so you can get to the filter holder. Push in the tab and pull the holder out like a drawer. remove it completely and install a new filter in the holder. 4. Install everything back the way it was and go for a drive.
To remove the rear cup holder on a 1998 Toyota Corolla LE, first remove the seat. Then remove the four bolts holding the cup holder housing.
Very Simple, there are usually located behind the glove box door. Most of the time the door will fall back that you can get at the filter. Most of them that I have done, you push on the sides of the door and then it will fall back revealing the filter. Theres a plastic cover or filter holder that you remove where the filter is located.
Open the cup holder and remove the two screws on the outside.