If you pry up on the pulley with a bar on each side of it and while keeping pressure on the pulley, hit the end of the shaft that the pulley is on with a brass mallet, the pulley will usually break free.
This requires a power steering pulley puller. This puller is designed to remove and install a power steering pulley without damage to the pulley and or pump. Attempting to do this without the puller will result in damaging the pulley or the pump or both.
To remove that pulley with out damaging the pump or the pulley you need a power steering pulley puller. This tool will also install the pulley. Your local auto parts store can rent or sell you that puller.
That is not a Allen screw in there. That is part of the pump shaft. If you are looking to remove the pump pulley you will need a power steering pulley puller. This tool will help you remove it and replace it, without the puller you will damage the pulley or the pump or both.
Go to www.zzperformance.com and you will be able to rent a pulley puller do not use a regular pulley puller they. It is about 30 bucks to rent. It will take about an hour to do
pulley puller
That requires a special PULLER. Need a power steering pulley Puller.
Pulley is pressed onto pump, you need a puller to remove.
That requires a special PULLER to remove the pulley.
Loosen, then remove the belt. Shine a light through one of the holes in the PS pulley and turn it slowly. You will see three bolts through the holes. Use a 13mm socket and a swivel to unscrew and remove these bolts. Lift the pump out of position and remove the hoses. Use a Power Steering Pulley Puller to remove the pulley. This puller grips the pulley by its center hub. Any other type of puller will destroy the pulley and then you will need a new pulley.
With a power steering pulley puller. Any attempt to remove the pulley without the proper tool will probably damage the pulley or the pump or both. Most auto parts stores will sell you the puller or rent you one.
On most newer cars, the crank pulley is one piece with the harmonic balancer.... Remove it with a harmonic balancer puller.
Use a puller so you do not bend the pulley.