Jack up the bike's rear end or put it on a special repair stand as it does not have a center stand. Put the bike in neutral gear. Use a socket wrench to loosen and unfasten the axle nut on the side of the rear swingarm. Remove split from axle nut if there is one with pliers. Unscrew and remove the axle nut. Then hit the axle end with a squarely with a hammer until it comes loose and you can remove it. Now, the rear wheel is free and you can slide it back from from the drive shaft. Remove the rear wheel completely from the swingarm. Give the brake lever a few pushes if brake calipers are stuck on the disc and keeping it in place, this should release them. Ease disc out of calipers with care.
28 psi front, 36 psi rear.
Front is a 120/90-18 and the rear is a 170/80-15. They been the same since 2000, when Honda reintroduced the Sabre.
In the rear luggage area, remove the carpet, - remove the folding table - it is stored underneath.
In the rear luggage area, remove the carpet, - remove the folding table - it is stored underneath.
The Honda Shadow Spirit, recommends 29 psi in the front tire and 32-36 psi in the rear tire.
I'm not sure what you mean here...are you wondering what tire size is on a 1992 Honda Prelude? Or, how do you get to the spare tire? Or, how do you remove a tire?
29 psi front tire, 38 psi rear tire.
28 psi for the front and 36 for the rear tire.
with the motorcycle on the ground install tire change tool from tool kit across the tabs on the frame then put motorcycle on center stand. Remove rear fender bolts to raise rear fender, remove axle bolt then remove rear tire.
front 32 rear 31
You must remove the wheel/tire in order to remove the front strut.
28 psi front, 36 rear.