Drain coolant Remove 4 bolts that secure fan and pulley on water pump Remove Belts Slide fan and pulley off water pump shaft Loosen and remove bolts securing water pump Remove coolant hoses if required Remove water pump Clean engine surface before installing new pump and gasket ya what he said......lol
It would be best to remove the alternator and take it to an electrical shop.
No, Chevrolet did not make a 1994 SS. The first year for the 4th Generation SS was 1996.
it says low traction
what is color scheme?
It is built into the engine control computor.
It is attached to the lower part of the engine block.
I have a 1994 Chevrolet Camaro and I work at a car lot where we have several salvaged cars and i need to know what other heater core will fit on my car. I have a 2005 chevrolet malibu classic heater core and they look almost the same. Will it fit
The 1994 Chevrolet Camaro power window relay switch can be found inside of the driver side door. You will need to remove the door panel to access the power window relay switch.
remove all the screws
1994 chevrolet camaro
No, those were 4-speed autos
It has no Governor. Speed is computer controlled.
I call a mechanic, someone who wouldn't ask the internet how to do it
take it to a mechanic.
you will have to pull the tranny out to change it and then you can pop it out with a screwdriver.
camaro* and its under the passenger side dashboard. you have to take the entire dash apart to get to it
It's in the gas tank so the tank has to come down to get it out.
If it is not on the fuse panel then it is on the back of the dash near the steering column.
You remove and install the engine from the top.
blown head gasket check oil and radiator fluid. i know these cars are for people named george
Remove the inside door panel of your 1994 Chevrolet Corsica. Remove the window motor wiring harness. Remove the window motor linkage. Remove the window motor retaining bolts. Reverse the process to install the new window motor.
Drain the water from your 1994 Chevrolet Blazer cooling system. Remove the heater core water supply hoses. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
On all fuel injected engines the fuel pump is located in the gas tank.
All components that have to have fluids changed have the drain plug on the bottom of the particular component.