Disconnect the 1988 Century battery. Remove the alternator battery. Disconnect the alternator wiring, then unbolt the alternator. Bolt in the new alternator, then reverse the procedure to finish the installation.
inside the alternator
Check out www.advanceautoparts.com and go to the search engine located on the right-hand side, over the picture of the US map. Type in Altenator and click on the SEARCH button. Click on ALTENATOR REPLACEMENT. Cntinue to follow the instructions and the information that you're looking for should appear.
disconnect negative battery tml.,remove the plug from the alternator,remove the main battery wire from the stud on the alternator, remove the lock bolt, swing alternator down to remove belt, remove pivot bolt, swing alt. until its out. replacement is reverse of remova; To take out the alternator on a 88' tercel, you have to do it from under the car
Remove your air cleaner housing, left front tire. unplug and unbolt your alternator and remove it up throw the air cleaner area.
What size motor? What accessories do you have? BClear.
If it is like a 1989 saab 9000, you remove the front passenger wheel, remove all the plastic from the wheel well, and the alternator should be rite there. You can also get to it by removing the manifold, which allows much easier access to the alternator, but then you need a new manifold gasket.
To remove the alternator on 1988 Honda CRX the negative battery must first be disconnected. The belt needs to be loosen and the mounting bolts need to be removed as well. When unmounted the alternator will slide off, and a new unit can be replaced.
How do you replace the alternator on a 1988 Pontiac Fiero
I have not tried this ...but looks very possible . Remove the air cleaner housing and tube . Think that there is 3 bolts to remove from the alternator . disconnect alt wiring .Move alt to pass side of car ...and lift up .
no, you do not need a compression tool to remove or replace them
Remove the Oil Filter and remove the Alt. through there. It will take some twisting and turning to get it out and In but it'll work
well first disconnect the battery, then remove the belt by using a pull bar at the pulley to release the tension of the belt to take off the belt, then unplug the wire harness that's plugged into the alternator then remove the 3 bolts from the alternator.
lift the car take the shroud away from the bottom i think it 5 screws unbolt the sway bar remove the alternator its 3 bolt replace the same way it came out
the alternator is located on the passenger side of the engine compatment close to the radiator on the top level of the engine. step 1- remove alternator belt via tention pulley, step2- unplug alternator step3- unbolt alternator ( there are 2 bolts, one long and one short) step4- remove alternator step 5- insert new alternator step6- reinsert bolts and plug new alternator in step7- place belt back where it was and your all done
Jack the car up in the rear and pull off the passenger side rear wheel. you will be able to see the slider that the alternator is mounted on. remove that bolt and clawl under the car to remove the top bolt from the alternator. the reason for this is that the alternator has to come out of the bottom of the car. you will want to be under the car to catch the alternator when it come loose. repeat steps in reverse to put alternator back on. use a bar to put tention on the alternator to get the proper tention on the belt.
I assume you have tried liquid wrench? I assume you have tried LiquidWrench?
you need to remove or loosen belt tensioner assist bolt that is attached to the top of the alternator
The shocks are there for a reason. Removing them would cause damage.
Remove serpentine belt, alternator, and power steering pump. Remove 4 water pump pulley bolts. Remove water pump housing bolts. Remove water pump.
the alternator is found on the left side toward the front you remove the three bolts holding it in place with a socket don't use a wrench itll just slip and youll just hit your hand on the head remove all belts from the alternator and carefully remove the alternator to make sure as to not damage any of the belts as it is removed then slide the new alternator in place and put the belts on you then can hook up all wiring and bolt it into place you've just replaced your alternator and this was written by a fourteen year old who loves cars
It's two bolts. There is a top alternator bolt and an lower adjustment bolt. Loosen both bolts enough to slip off the alternator belt. Remove the bolts, and then slide the alternator down and under the car through the passengerside wheel well. Installation is the reverse of above.
It's on the firewall up high on the passenger side. You may need to remove the alternator to get it out.
Hou much should it cost to replace an alternator for a 1988 acura integra Ls?
There is no fuse for the alternator shown in my factory service manual.