0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change an alternator remove 1999 mystique?
Begin by removing the belt from your 1999 Mercury Mystique alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
Where are the rear speakers in a 1996 mercury mystique car located?
the rear speakers are located in the back doors. you have to remove the door panels to get at them.
Where is the knock sensor located 1999 mercury mystique?
Low on back side of engine block.
Where is the oil pump switch sensor in a 1998 Mercury Mystique?
on the back of the block behind the intake
1999 Mercury Mystique shocks or struts?
Struts on the front , but motorcraft.com lists shocks and struts for the back ( I'm confused ! )
How do you remove compressor belt on a 2000 mercury villager?
Loosen the tensioner locking bolt and and back off the screw. Consult a manual if you are not familiar with how to do this.
Can you show picture on how to remove the rear back seat 1999 Mercury sable?
How can remove the rear seat on a 1990 mercury sable
Where is the starter for a 2000 Mercury Sable?
The 2000 Mercury Sable starter can be found on the right hand side of the engine. The starter will be near the back of the engine.
How do you get to the fuel pump 2000 mercury cougar?
it is under the back seat
Where is the alternator on a 2000 Mercury Cougar?
passenger side bottom back of the engine. to get at it you need to lift the car, remove the front passenger wheel, and take off the splash guards
How do you remove back seat in 94 mercury villager?
You remove the center seat and slide the back one up into it's place.
How do you change the heater fan control switch in a 1996 Mercury Mystique?
Remove the center dashboard by using a flat head screwdriver as a lever. Disconnect the wire connections,use a screw driver to remove the plug in port for the fan control, replace with a new one, reconnect the wire connections, and push the control panel back in its place.Ê
