remove the 2 bolts at the bottom of the seat and then remove the bottom of the seat. Then remove the two star bolts at the bottom holding the seatbelts in place, then lift the seat on both sides to remove the back of the seat from its clips. Then your all done
No, You must remove the fuel tank.
passenger side back seat, behind the panel by the door. may have to remove floor panel and/or seat.
How do I remove the female seat belt assembly on a 97 ford exploer?
The jack is located under the rear seat on my 1997 Jeep Grand Cherokee.
Under back seat.
remove rear seat panel
Order a new seat locking lever from FORD, it should be accessable from the drivers side where you adjust the seat.
how do you remove ash tray assy in 97 pontaic grand prix gtp sc
Use a 10mm socket.
to remove or change rear speakers on 97 to 03 grand prix..where carpet meets the bottom of rear bench on each side there is tabs, pul tabs and lift out rear seat ,there are two bolts holding in the bottom of the seat back one on each side above the seat pots.Remove the seat back by sliding up then out towards front of car(don't force hard! slide up first then pull outward!)the rear deck has bolts holding it down now in plain sight. remove the bolts/screws and slide the seat belts out of the deck and remove upward and out. You will now see the speakers are screwed in from the top. ps. unplug the 3" or 31/4" whatever they they are crap!use good 6by9 capped for 80!
Remove the plastic shield that surrounds the underneath of the fuel tank the two straps connect the hoses wire connectors probably easier to disconnect the wiring from inside the trunk or take the back of the back seat out became
It is located under the passenger seat. If you need to replace the amp it is best to first remove the passenger seat. In a '97 there are 5 bolts that hold the seat in. The fifth one is in the middle of the seat runner on the door side. Good lick!