reset button is on dash to the right of steering wheel
You have to take off the whole dash board to get to the center console!
If you are able to see the cd, or at least an edge, try to pry it out very carefully with something thin, or using pliers. If it is hard stuck, your only option is to remove the player from the dash to get at the cd.
There is no 2005 Ford Windstar. In 2004 the name was changed to Freestar. The switch will be in one of these locations. Under dash on passenger side, just past the transmission hump, or console, on the upper part of the floorboard, behind the passenger kick panel, or in the trunk.
How do your remove the dashboard on a 2000 Ford Ranger?
In order to remove the stock radio from a 2005 Ford Freestar, u must first get either a flathead screwdriver with a very thin tip or something sturdy enough to be able to handle a little pressure while prying the wood grain paneling off around the a.c controls and radio. " PLEASE NOTE" whatever is used to get the paneling from around the radio needs to be thin enough to fit in the cracks between the actual dash and paneling around the radio. once the panel is off the rest pretty much answers itself, just remove the screws and pull it out gently to avoid tugging on the wires hooked into the back
how to remove the vent from dashboard of 1996 ford contour
You don't.
I was looking at the 2004 Ford Freestar Owner Guide and it shows that the SINGLE switch for the power vent windows is located on the dash ( but not where on the dash , not much help ! ) The switch has " VENT " on it
It is the fuse box for things like power windows etc. It is located on the drivers side just above the dash.
To open the fuse panel, you will need to fit yourself between the dash and the drivers seat. Once there, you should be able to see the clips that are holding the cover on the fuse panel to allow you to remove it for access.
To remove the dash to get to the radio from a 2005 Kia Optima, begin by prying around the edge of the trim around the gear shifter. Then, remove the screws from the bottom of the dash and pry the trim away from the radio area. This will expose the radio bezel.