there are 2 screws (1 at each end) behind little snap in covers on the pull handle, remove them. 2 more i think where the handle you open the door is at, the rest should just be held by plastic studs that are just pressed into the door.you just slide a flatbar between the panel and door and pry them out. though it usually tears them up removing them.
u have to grind the hinges
with a hammer
How do you remove calipers from a 1987 thunderbird? Like where do I start?
What engine do you have?
Replacing a door panel in a 1988 Ford F 150 is very simple to do. The only tool needed to remove the door panel is a Phillips screwdriver. You will need to unscrew the screws on the door panel only to remove. It should take less than 10 minutes.
You can replace the locking cylinder, on your 1994 Ford Thunderbird, by removing the inside door panel. The locking mechanism will be visible with the door panel removed.
in the gas tank
No. The 1996 Ford Thunderbird does not have a fuel pump access panel. You would need to get the car on a lift and then drop the gas tank. Then you can reach the fuel pump.
Four rivets hold the regulator asm on the door panel but the switch is more than likely the problem.
It snaps in and laps over lower part of window one bolt by door handle
I have the original owners manual for a Ford 1968 Thunderbird. I scanned an image of the diagram and posted it here: http://www.opensourceopportunities.com/Ford-Thunderbird-1968-fuse-diagram.jpg
you will have to have this evac by a a/c tech.