0
Loosen the 18mm bolt about 4 or 5 mm and give the bolt a good wack and the pulley should pop. Then remove the bolt and pulley.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you remove engine shroud on 2006 jetta?
The 2006 VW Jetta engine shroud is held in place by several retaining bolts. You will need to remove the retaining bolts.
Where is the crankshaft located on a 1998 volkswagen jetta?
It is in the crank case at the bottom of the block. The pulley that drives all the engine accessors is mounted on one end of it and the flywheel or torque converter, depending on automatic or manual, is mounted to the other end.
Is there a crank shaft sensor in a 97 jetta?
yes there is but i am unsure of where it sits on the engine. i am unable to get spark to my plugs and most people have told me the problem is the crank sensor.
Where is the crank sensor located on a 2001 jetta 2.0 gls?
at the rear of the engine block to the right of the oil filter.
Where is the water pump on a 2001 jetta vr6?
The water pump on the VR6 is located on the engine. To access, you have to remove: 1) Engine Cover 2) Center and right insulation trays 3) Drive belt 4) Breather hose on cylinder head cover 5) Drain coolant 6) Support engine, and remove bolts from engine mount 7) Lower engine until pump can be removed 8) Remove pulley from pump 9) Remove bolts and push engine to side to get the pump out It is about a 5 hour job. Check out our website for Volkswagen Jetta performance parts and other technical guides.
Where is cylinder 1 on vw jetta 2.0 engine?
The cylinder. Positions are marked on the main front pulley. Manually turning the pulley to the number one position and the number one cylinder will be in position.
How do you find top dead center on a 2000 jetta 1.8t?
To find the top dead center on a 2000 Jetta 1.8T, remove the engine splash guard inside the wheel well on the right side. Locate the main crankshaft pulley nut and see the intake manifold. That is the top dead center. ?æ?æ
How do you change a crank sensor on a 1999 Jetta 3 2 0L?
The distributor is the crank sensor. If the timing belt was changed and the check engine light came on, the shaft that drives the distributor could be out of time.
How do you replace a crank sensor on a 2004 jetta?
How_do_you_replace_a_crank_sensor_on_a_2004_jetta
How do you remove engine cover on 2008 jetta 2.0?
To remove an engine cover from a 2008 Volkswagen Jetta all of the mounting bolts need to be located. There are several around the engine bay. The clips for the air intake need to be removed as well. When everything is unbolt the cover can just be pulled off.
How do you replace an alternator in a VW Jetta?
Hi, if you are still looking. gas engine Jetta: remove negative battery cable. remove positive cable on alternator. remove blue wire on alternator. Loosen and remove mounting bracket (on top of alternator) be careful not to lose any of this bolt (very hard to find replacements). Remove alternator belt. REmove lower mounting bolt. Remove from engine. Reverse to install. All done. diesel Jetta: mounting bracket is on the bottom and engine mount is on the top. that's the only difference. same procedure. have fun!
What is the firing order for a VW Jetta 1991 4-cylinder 1.8?
The firing order for a VW Jetta 1991 4-cylinder 1.8 is 1, 3, 4, 2. The number 1 cylinder is closest to the pulley on the engine.
