you have to open the glove box and remove the 2 screws from the left side then if you remove the ash try there is a screw there that you need to take out then you should be able to pull out where you just removed the ash try and slide down that part of the dash and then it should just be 2 screws holding in the radio from there ****REVISION****On the 1994 S10, (1) disconnect neg battery terminal to prevent an accidental short circuit. (2) remove 2 screws above the speedometer cluster. (3)remove ashtray and 1 screw exposed in the upper left corner of the ashtray cavity. (4) remove 2 screws from the lower steering column trim bezel and remove bezel. (5) unclip the dash trim bezel by pulling away from dash, disconnect the light switch and dimmer wiring and remove the bezel. (6) remove 4 screws securing the air mover controller. (7) remove 4 screws securing the factory head unit/pocket assembly and disconnect wiring and antenna.
Remove the retaining cover from your 1994 Chevy S 10 pickup truck radio. Remove the radio retaining bolts. Slide the radio out. Remove the wiring harness and the antenna cable from the back of the radio.
Begin by removing the decorative cover from your 1990 Chevy Caprice factory radio. Remove the radio retaining screws. Remove the wiring harness and the antenna cable from the back of the radio.
Remove the retaining cover to your 2005 Chevy Malibu radio. Remove the radio retaining screws. Slide the radio out. Remove the wiring harness and the antenna cable.
remove bezel that covers radio and hvac controls, two ten millimeter bolt hold it in, unhook wiring pack(s) and antenna wire.
Remove the cover from your 1986 Chevy Cavalier radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
no
you pull it out
How to remove the factory radio and disconnect wirring harnes in a 2004 f150 ford truck
Begin by removing the decorative radio cover from your 1981 Chevy Corvette radio. Remove the radio retaining screws. Slide the radio out and remove the wiring harness and the antenna cable.
yes
Around $100
no sorry