On the Signal Assembly there is only ONE screw which is right on top, near the headlight. It looks like a little arm sticking out, unscrew it.
Now, on the passenger's side signal assembly, pull from <----RIGHT to LEFT gently in between the crack of the Headlight and the Signal Assembly. In other words, pulling opposite from the 'Isuzu Logo". Apply force slowly and as necessary. It will pop out!!
You will see the Signal Assembly is held into place by two separate plastic prongs that fit snugly into small holes. :)
wear gloves, bearings all come out. then you have to remove the sensor off the back of it. along with 6 17mm bolts. How do you change the rotors in the front on a 1998 Isuzu Trooper
On top in front of engine
The dipstick for the 1995 Isuzu Trooper is located near the front of the engine, typically on the passenger side. It is usually a yellow or orange handle, making it easily identifiable. To access it, simply pull it out, wipe it clean, reinsert it, and then remove it again to check the oil level.
Lift the hood of the Trooper. Remove the mounting screw on top of the head lamp housing near the signal lamp housing (1 Phillips screw). Pry the signal lamp housing gently towards the front of the vehicle. There is a snap mount keeping it in.
The thermostat on a 1998 Isuzu Trooper is located on the front of the motor. It is in the top radiator hose where it connects to the motor. To access the thermostat, the hose needs to be disconnected from the motor.
my 1995 Trooper had same problem it was the crankshaft position sensor located on the middle passenger side of the motor. I will remove the passenger side front tire and it is behind the shock, tight fit but can be done.
passenger side of motor, top, in front of fire wall
The firing order for a 99 Isuzu Trooper 3.5l is 1, 2, 3, 4, 5, 6. The number one cylinder is on the left side in the front as you are facing the car.
you have two seats in the front, and a bench seat in the back
remove the six lug nuts
I believe, you have to remove the caliper and bracket. Then remove the axle nut. All the bearings will come off. A very messy project. They are not just knock off rotors like most cars.
hoew do you remove a c v axle from a 97 isuzu rodeo front right