0
First remove distributor cap.
loosen the bolt that holds down distributor and take holding plate of
MAKE SURE YOU MARK DISTRIBUTOR POSITION AGAINST BLOCK AND ROTOR AGAINST DISTRIBUTOR HOUSING.
pull out distributor from engine.
now take out the pin that holds the gear on the distributor rotor shaft
take the gear of the shaft, position of gear on shaft is not important.
now from the the top of the distriburator pull the rotor shaft out and wow la.
camshaft position sensor is ready to be taken out.
To install just reverse the steps and when you ready to install the gear on shaft make
sure that the gears is against the distributor housing and not on the tip of the shaft (up side down).
installing distributor on engine. install the the rotor on shaft and turn it about 20
degrees clock wise so when you push the distributor into the engine is going to turn
back to the original position.
You are welcome
jcdl. 7-10-08
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the speed sensor located on a 1998 jetta?
right in front if the battery terminal on the transmission
How do you remove the crankshaft sensor from a 1998 Chevrolet Blazer?
Unplug the electrical connection at the sensor. Remove the small bolt and retainer holding the sensor in place. Remove the sensor.
How do you test a 1998 jetta engine speed sensor?
the vehicle speed sensor is on the tranny it hooks onto your speedometer. the engine speed sensor is on the front of the engine, two different sensors guys.
How do you remove o2 sensor from 1998 Chevy silverado?
unscrew it
How do you remove a starter from a 98 jetta wolfsberg edition can't find the rest of the bolts?
Begin by removing the positive cable from your 1998 VW Jetta battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. There will be three starter retaining bolts.
Torque specs for a 1998 Volkswagen jetta 2.0?
Torque specs for a 1998 Volkswagen jetta 2.0
Where is the O2 sensor on a 1998 VW Jetta GLX?
The oxygen sensor is usually located on the exhaust system. You should find it just after the exhaust manifold and just ahead of the ctalytic converter...Don the Juan.
How do you install a throttle position sensor on a 1998 mercury villager?
remove and reinstall
Where is the air intake temperature sensor a 1998 peugeot 106?
it is located on the inlet manifold below throttle body you need to remove manifold and remove sensor from underside
What is the sensor behind the oil filter on a 1998 dodge neon how do you change it?
The sensor behind the oil filter for a 1998 Neon is a crankshaft position sensor. Unplug the wiring and remove the hold down bolt to replace it.
Will a 2001 VW jetta transmission fit into a 1998 VW jetta?
No, not without modifications.
Where is the crankshaft position sensor located on a 1998 Mitsubishi Eclipse?
Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.
