Right under the rods of the headrest there is two round plastic pieces the rods go through. About one inch below the plastic pieces on the front of the seat even with the rods is the release. Press in and have someone pull up the headrest. You can follow the rods down the seat until you fell two small bumps. The bumps are the release for each side.
Remove the cylinder had from your 1997 Chevy Astro engine. Remove the head gasket and clean the surface. Put the new head gasket on and reverse the process.
Remove the tire and wheel from your 1997 Chevy Astro. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new front wheel bearing.
fireing order for 1997 astro van v6
what is wrong when your gages on dash board stop working on your 1997 chevy astro van?
remove the inner pannel. That will put you at the assembly. with windo up, remove assemblt. then replace
Is anyone on line to help me with this question? Where is the fast idle thermal valve in a 1997 Chevy astro van located?
The Astro does not have a flywheel, it has a flexplate. To remove it you have to remove the transmission so you can unbolt it from the crankshaft.
Astro 4WD Base: 29.370$ Astro 4WD LS: 31.895$ Astro 4WD LT: 34.600$
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
I haVE A 1999 CHEVY astro and it holds just over 25 gallons. once ran out of gas and then had it filled.
in the fuel tank
The door lock remote control receiver for a 1997 Chevy Astro van is located inside the cabin. it is found on the right kick plate.