Nissan Sentra

How do you remove hub and bearing on 2000 Nissan sentra?

567

Top Answer
User Avatar
Wiki User
2008-05-18 12:57:45
2008-05-18 12:57:45

remove the steering knuckle, put it in a vise and if there are no snap rings inside the axle opening, get a big hammer and go at it.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is the crank sensor located on 2000 nissan sentra

User Avatar

how many liters of transmission take for Nissan sentra gxe

User Avatar

I have a 2001 Nissan Sentra SE and it was suggested I change it every 100,000 miles.

User Avatar

How do you remove stereo from 2000 nissan pathfinder?

User Avatar

For example a 2000 Nissan Sentra and a 2000 Daewoo Laganza are the same heater core but the Maxima is not..............

User Avatar

Simply locate the starter, and it's a remove and replace operation. A couple of bolts, a couple of wires and your back in business.

User Avatar

hello ,go to autozone{car store] and ask any staff member for help>good luck

User Avatar

At the outlet to the fuel injection hose.

User Avatar

Some are 1.8 &ready se is 2.0

User Avatar

Remove the tire and wheel. Remove the axle end cap. Remove the wheel bearing retaining nut. Remove the wheel bearing seal. Remove the wheel bearing. Reverse the process to install the new wheel bearing.

User Avatar

No - the 2000 Sentra has a timing chain. No - the 2000 Sentra has a timing chain.

User Avatar

The 2000 Nissan windshield wiper fuse is located in the fuse box. The windshield wiper fuse will be in the second column, third from the top.

User Avatar

Remove the door panel. remove the speaker by removing the screws. If replacing the speaker won't fix it check the door wiring for continuity as they break from years of opening and closing the door. Cheers

User Avatar

How do you remove a distributor on a 2000 nissan xterra

User Avatar

I drive a 2000 Nissan Sentra GXE. Currently I have about 145,000 miles on it. I spoke to my mechanic regarding this and he said since its a chain, it never needs to be changed. No change is required.

User Avatar

Trouble code P0175 means: System Too Rich (Bank 2)

User Avatar

the part numbers should be on a sticker on top of the unit itself

User Avatar

the ecm plug should be located under the dash beneath the steering wheel.

User Avatar

Diagram replacement linkage for wipers 2000 Nissan Xterra.

User Avatar

You use the test monitor and scroll down to clear code

User Avatar

A 2000 Nissan Sentra GXE with the 1.8L engine has a timing chain, not a belt. There is no specific recommendation as to when to replace the timing chain. In most cases, chain-driven vehicles can go for well over 150,000 miles before the timing components are in need of replacement.

User Avatar

to remove the spindle and four bolts hold the bearing assembly to the "A" frame. remove the wheel, remove the control arm, remove the lower "A" frame , and remove the CV axle. then you will have acess to the 4 bolts that hold the bearing assembly. you will have to buy the whole assembly.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.