Want this question answered?
It cannot be produced by Milling machine...where it can be done by Forming and Rolling and turning methods..
A multithreaded system comprising of multiple user-levelthreads cannot make use of the different processors in a multiprocessorsystem simultaneously. The operating system sees only a single processand will not schedule the different threads of the process on separateprocessors. Consequently, there is no performance benefit associatedwith executing multiple user-level threads on a multiprocessor system.
Fitting carpet would help to reduce heat loss because the carpets fibres grip onto the air, so therefore the warm air cannot escape from your home. Also, the thicker your carpet is, the more warm air it will trap, so it will be a better insulator for you home if it is a thick carpet =)
Rising stem gate Valve- Stem threads are out side of valve body and in no contact with fluid medium. Stem rises while opening the valve (by hand wheel). Since the stem threads are located outside obviously it needs some more vertical clearance space while opening the valve.Non Rising Stem gate Valve - Stem threads are inside the the valve body and it is in contact with fluid medium. Hence, lot of chances for fouling the threads and these types of valves only can be used in clean liquids and gases. Less vertical clearance space required while opening the valve.
Threads in distributed applications have the same benefits as in any other application: they allow you to perform multiple operations at the same time. Specifically for distributed applications, the server will most definitely be multi-threaded so that it can communicate with all of the clients. The clients will also most likely have at least two threads: one for communication with the server and one for doing actual data processing.
Compression uses a ferrule or brass ring around the pipe that is compressed by the nut into the pipe and against the fitting. There is no such thing as Female Pipe Threads. There are Male and Female fittings, the pipe is the Male side and the fitting is Female. The Male goes inside of the Female. They both have pipe threads. Pipe thread, Compression, and Flare all have different thread pattern so that they cannot be mixed. They all do different jobs.
Cannot be broken
NO you cannot heat as any flame can cause a severe explosion and the very least crack the CI fitting The threads have to be cut out gently and possibly re tapped
Just because you protect threads with critical sections does not mean the threads cannot be interrupted by the system. What it does mean is that, if the threads are correctly protected with the same critical section, the threads cannot interrupt each other. If this is not true, then your code is defective. Make sure the thread blocks when the critical section cannot be entered, and that it properly releases the critical section when it is done.
An element is the only substance that cannot be broken down.
The atom cannot be broken by chemical methods.
All of the elements of the Periodic Table cannot be broken down into simpler substances.
Atoms cannot be broken down into simpler substances
an element is a substance that cannot be broken down into a simpler form by chemical means
It cannot be produced by Milling machine...where it can be done by Forming and Rolling and turning methods..
molecule
An element cannot be broken down into a simpler substance by chemical means.