after removing the two nuts from the rear light how do tou get it out of the rear panel
To remove the tailights from a Daewoo lanos undo the two screws on the inner side of the light housing with the hatch open and and then gently lift or lower depending on which side it is and remove from the rear holders
12.4 gallons and your light should come on at 1.5 gallons
If there is a red blinking light on top of the dashboard(blinks every second or so), then, yes, it is!
If you google Daewoo Owners club website and go to the Lanos forum. There is a down loadable PDF for a Lanos in the permanent post at the top of the page. The manual covers the 1.3 & 1.5 SOHC and 1.6L DOHC. It has all necessary info. The info you are looking for is on page 1645, Park netural safety switch, located on the top rear of the transmission (auto) where the shift cable connects.
You will need to remove the tail light covers in the cargo compartment. Remove the wiring harness. Remove the tail light assembly retaining bolts.
You can access the Nissan taillights from the cargo compartment. Remove the tail light assembly cover. Remove the tail light wiring harness. Remove the tail light assembly retaining bolts.
you need a scantool that has a daewoo compatible cartridge, so you can access the srs computer, a regular scantool like the ones at advance wont do it. you need a scantool that has a daewoo compatible cartridge, so you can access the srs computer, a regular scantool like the ones at advance wont do it.
Open the trunk and remove the nuts holding the assembly in place. With nuts removed the tail light assembly will come out the back then you can remove the light socket to replace the bulb.
Do you have a check engine light. I have had problems with my 01 Lanos and the check engine light came on and it was the oxygen sensor so that may be your problem
drop the tailgate on side of bed where tailgate closes are couple of screws. thses hold the light assembly in bed. remove thse ,then remove light assembly light bulb is the able to be removed from back of assembly
I had this problem on my R reg Lanos. It was the Idle Air Control valve letting too much air into the engine. My mechanic simply cleaned it and it has been fine ever since. If it needs replacing they are about £100.
In order to change a bulb in the tail light of a Chevy Celebrity you must remove the tail light assembly from the car. To remove the tail light assembly" 1. In the trunk next to the quarter panel there are nuts that hold the rear header on, the center nut holds the tail light assembly on. It will be in the center of the tail light assembly near the outer edge. Take the nut off and pull the tail light assembly out until the stud clears the body. 2. Pull the tail light assembly to the side to disengage the tabs from the backup light panel. 3. Twist the appropriate socket to remove it from the tail light assembly, then unplug the lamp and replace it. Reverse the steps to reinstall the tail light assembly.