It varys from each car but I think you have to take off the door panel. Next you locate the bolts and remove from there.
The keyless entry module on the 1997 Suburban is under the dash on the driver's side. The driver's side door needs to be open to see it.
Remove the 1997 Chevrolet Suburban drivers side door panel. The window mechanism will be visible. Place the new window into the window track. Secure the window to the track.
Remove the exterior side mirror turn signal cover. You can remove the cover by prying outward on the retaining clips. Take hold of the lightbulb, push in and turn at the same time to remove. Reverse the process to install the new lightbulb.
the starter on a 1997 Suburban is on the side of the engine. It is at the rear where the transmission meets the engine.
You will have to remove 1 valve cover.
On the bottom of the door mount is a screw. Remove it, and push the case up. There's four 5/16 bolts. If it's power mirrors, there's a wiring harness inside the door you'll have to disconnect.
* Remove the door trim panel * On power mirrors unplug the electrical connector * Remove the triangular cover over the mirror mounting * Remove the bolts and detach the mirror from the door * Installation is the reverse of removal
If you want to remove the clear downward ground light on the mirrors. You have to pry out the clear lens.
On the driver's side next to the distributor; hard to get to.
To remove the mirrors from you Nissan Sentra first remove the inside door panel. Pry the plastic mirror cover off of the mirror. Once this is done remove all of the nuts, bolts, or clips holding the mirror to the door.
Remove the inside door panel. Remove the wiring harness. Remove the mirror retaining bolts. The side rear view mirror will come off.
Most cars have an inside cover over the bolts that hold the mirror on. I would expect a 97 Accent to be the same. Most just pop on, some have a screw in one corner.