Being an auto tech.. I looked to see the easiest way to get the starter out. Like you my starter on my old 3810 had seen better days.. The only and not so hard way to get to the starter bolts is.. to take the engine out. Only 4 motor mount bolts, remove the hood, Throttle cable and various connectors. The good thing is the driveshaft just sits inside the flange unit, so once the engine is free, simply pull it out of the chassis. OOPs PS the muffler has 2 nuts and a couple of 10 mm for the shields. Once free put the engine assembly on the workbench, pull off the shroud unbolt the shaft flange, loosen the nut for the flywheel, I sprayed around the flywheel nut area. Get a rubber hammer, smack each side of the flywheel and rock back and forth. Once loose remove the coil assembly. There you will finally find the starter bolts.. This took me a good 2 hours but a great learning experience.. I didnt want to just rebuild the unit to again get stuck this winter.. go new.
i need to see belt digram for a 4518 honda riding mower
form_title= Honda Lawn Mower form_header= Mow your lawn easily with a Honda lawn mower. What is the square footage of your lawn?*= _ [50] Do you need to repair an existing lawn mower?*= () Yes () No Do you want a push or riding mower?*= () Push () Riding
which 42" Craftsman riding mower is made by Huskvarna
yes
No, you can charge it on the mower and you do not have to remove it or disconnect the cables.
You should be able to turn the starter with little effort when it is not engaged with the flywheel.
Place mower near street with FREE MOWER sign. That is the best way to remove the clutch/drive on this POS mower.
its probly flooded.
to get rear wheel off yardman mower
33oz.
Neither Honda is the most reliable powerful and strongest on the market. Get the honda
Dynamite