answersLogoWhite

0


Best Answer

There is a 10mm bolt located right around the 60/40 split. You can see it if you lower the left back rest about halfway. It isn't necessary to lower the backrest to remove the bolt, it just helps you see where it is. After you remove the bolt lift the seat from the backside as if it were hinged at the front. Once the seat is around 90 degrees up just pull up and the seat is out.

User Avatar

Wiki User

โˆ™ 2006-09-17 01:12:32
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove the back seat in a 1990 Acura Integra LS?
Write your answer...
Submit
Related questions

How do you remove the back seats from a 1994 Acura Integra gsr?

The back seats on a 1994 Acura Integra are mounted on bracket that attach to the body of the vehicle. Push the back of the seat down and loosen all the bracket bolts. Pull the seats out.


How do you turn your back lights of your 1990 Acura Integra off?

It needs to have a separate switch for the front and rear lights.


How do you replace an alternator on a 1990 Acura Legend?

Remove the belt from your 1990 Acura Legend alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


Where is the themostat on the 1996 Acura Integra locate?

If yoor 1996 Integra has the1.8L engine, the thermostat is located at the back of the motor at the end of the bottom radiator hose.


Where is the fuel pump located on a 1991 Acura Integra Ls?

its physically inside of the fuel tank. You must remove the back seats to get to the little plate that has three screws and take that off to get to it


How do I remove the rear speakers in a 1996 integra coupe?

You will need to remove the covers from your 1996 Integra rear speakers. Remove the speaker retaining screws. Remove the wiring harness from the back of the speakers.


How do you remove radio from 98 Acura Integra?

You have to take out the center consol behind the parking brake then remove the cover over that is around the shifter lever then theres 2 screws when you look up from the floor the are screwed into the back of the unit.


How do you change fuel pump 1995 acura integra?

remove back seats, full access to fuel pump. disconnect all wires and lines (wear protective glasses as fuel is pressurized)


Where is the fuel pump relay at on a 1990 integra?

I believe it is underneath the back seat.


How do you replace the left rear brake light bulb on a 1998 Acura Integra hatchback?

On a 1989 Acura Integra hatch back the brake lights are reached through the hatch itself. The brake lights housing are on the rear of the vehicle. Unplug the bulbs and replace them.


Where is the fuel pump to a Acura Integra located?

what year? well usually located in the fuel tank remove your back seat and you will see an electrical connector going to the fuel tank that's to power your pump


Where is the fuel pump on a 1991 Acura Integra RS and how do you change it out?

I own a '93 GS and if it's anything like mine (and from what I understand, the fuel pump location for Integra is fairly universal) it's inside the gas tank underneath the back seat. You need to remove the rear seat to get to it.


Where exactly is the fuel pump relay located at on a 1990 Acura Integra?

It is going to be in 1 of 3 places. Under the hood in the fuse/relay box, under the dash near the steering wheel, or under the back seat.


What are the steps for replacing a fuel pump on an 1990 acura integra after removing the back seats and the three screws on its cover?

im not sure but on the 90 acura integra, the fuel pump is beside the gas tank on the driver side, that is the fuel level sending unit The pump is in the tank. undo the nuts on the top and pull the top up. connected to it is the pump itself. pull the connecter and hose off and replace. then replace the strainer and put back together


Where is a wire diagram for a 2000 Acura Integra?

Buy a manual from an auto zone or advanced auto parts its in the back of the book


When upper radiator hose on 1993 acura integra is removed there is no thermostat any ideas?

theromstat housing on the back not the front


How do you get your 1990 acura Integra ch eck engine light off?

disconnect your negative battery terminal for about 10 minute then reconnect it. If it comes back on you my need a repair shop to reset it or check to see what is making the light come on


How do you replace your 1990 integra distributor cap?

there should be three bolt on the side of the cap, remove them and make sure yoiu mark where your sp wires goes.If not LOUD BACK FIRE..........


Where is the computer located on a 1990 Acura Integra 4-door ls?

Underneath the passengers seat Actually its on the passenger side but on the front of the floor board. Just peel back the carpet on the front passenger side and you will see it


Where is the thermostat in a 95 Acura Integra LS?

The thermostat on a 95 acura integra ls is located on the left back side of the engine. below the intake. You will see a sensor plug-ed into it. The thermostat has 2 ten mill bolts holding it together and they are a pain. The best tool for the job is a ratchet wrench.


Where is the started located on an Acura integra?

The starter is located on the back of the engine, near the bottom. You can follow the positive cable from the battery directly to the starter.


How do you replace the back speakers in a 2006 Acura TL?

To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.


How do you replace a speedometer cable on a 1990 acura integra?

Start by removing the gauge cluster, unhook the speedometer cable from back of cluster. Pull speedo cable thru the firewall, follow it down to the transmission, and then unhook it. Install in reverse order of removal.


Where is the connector to hook up A OBD 2 on a 1995 Acura Integra?

Acura actually doesnt have an OBDII connector. Acura uses a silver box underneath the carpet where the passengers feet would be. Remove the carpet or pull it back some to reveal it and it will flash your code. I.E. flash pause flash flash flash flash means it has stored error code 1 and 4


What is the stereo code for a 2000 Acura Integra?

Each stereo has a unique code. The only way to get this code is to take it to an Acura dealership. actually save a trip and get the Code off the back of the raido and call a acura dealership and give them the code and they will give you yours

Study guides

๐Ÿ““
Create a Study Guide